Alpine HCE-TCAM1-WRA Installation Guide
Alpine HCE-TCAM1-WRA Manual
 |
View all Alpine HCE-TCAM1-WRA manuals
Add to My Manuals
Save this manual to your list of manuals |
Alpine HCE-TCAM1-WRA manual content summary:
- Alpine HCE-TCAM1-WRA | Installation Guide - Page 1
Support HCE-TCAM1-WRA with X009-WRA HCE-TCAM1-WRA Installation of HCE-TCAM1-WRA with X009-WRA ONLY When installing the HCE-TCAM1-WRA with the X009-WRA, X009-WRA Key Panel GPS Antenna To SXM Document Illustrated and Approved By: Phillip Bowen Date: 9/2/2016 Technical Support Alpine Electronics
-
1
 |
 |
This document will be subjected to change without notice.
Technical Support
Date: 9/2/2016
Revision: 012915
Document Illustrated and Approved By: Phillip Bowen
Technical Support
Alpine Electronics of America, Inc.
1-800-TECH-101
HCE-TCAM1-WRA with X009-WRA
Additional Specifications:
N/A
Circuit Profile:
N/A
HCE-TCAM1-WRA
Installation of HCE-TCAM1-WRA with X009-WRA ONLY
When installing the HCE-TCAM1-WRA with the X009-WRA, you must
cut the brake and reverse trigger wires from the T-harness, run them to
the passenger kick panel and connect them to the OEM brake and
reverse wires.
iDatalink MAESTRO Module
10-pin Green
Connector
(Vehicle signals)
3-pin Black
Connector
(Power)
To HCE-TCAM1-WRA
Connect the
Orange/White wire to
the White/Gray wire
located in the passenger
kick panel
Connect the
Yellow/Black wire to the
White/Black wire located
in the passenger kick
panel
HDMI Input
To SXM
Aux
X009 Head Unit
X009-WRA
Key Panel
GPS Antenna
Note: OEM wire colors were verified on tested vehicles,
colors may be different. To ensure proper operation,
iDatalink MAESTRO Module
18-pin
Conn
4-pin Blue
Connector
(SW Remote)
10-pin Green
Connector
(Vehicle signals)
3-pin Black
Connector
(Power)
Blue Power Antenna
Blue/White Amp Turn-on
Main Harness