Alpine INA-W900BT Owner's Manual (English) - Page 87
Indication for CD/MP3/WMA/AAC, Indication for DVD/CD
UPC - 793276100276
View all Alpine INA-W900BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
CD-R/CD-RW playback not possible. • Close session (finalization) has not been performed. - Perform finalization and attempt playback again. Error displays. • Mechanical error. - Touch [Eject] of Disc on the Eject/Tilt screen. After the error indication disappears, insert the disc again. If the abovementioned solution does not solve the problem, consult your nearest Alpine dealer. MP3/WMA/AAC is not played back. • Writing error occurred. The CD format is not compatible. - Make sure the CD has been written in a supported format. Refer to "About MP3/WMA/AAC" (pages 38 and 39), then rewrite in the format supported by this device. Unit does not operate. • Monitor's power is not turned on. - Turn on the monitor's power. • Condensation. - Wait a while (about 1 hour) for the condensation to dry. No picture is produced. • Monitor's mode is not switched to the mode you want to see. - Switch to the mode you want to see. • Monitor's parking brake lead is not connected. - Connect the monitor's parking brake wire and set the parking brake. (For details, refer to the monitor's instructions.) Playback does not start. • Disc is loaded upside-down. - Check the disc and load it with the labeled side facing upward. • Disc is dirty. - Clean the disc. • A disc not able to play back with this unit is loaded. - Check if the disc is able to be played back. • Parental lock is set. - Cancel the parental lock or change the rating level. Picture is unclear or noisy. • Disc is being fast-forwarded or fast-reversed. - The picture may be slightly disturbed, but this is normal. • Vehicle's battery power is weak. - Check the battery power and wiring. (The unit may malfunction if the battery power is under 11 volts with a load applied.) Image stops sometimes. • Disc is scratched. - Replaced with a non-scratched disc. Indication for CD/MP3/WMA/AAC • No disc is inserted. - Insert a disc. • Although a disc is inserted, "No Disc" is displayed and the unit does not start to play or eject the disc. - Remove the disc by following these steps. Press for at least 3 seconds. • Mechanism error. 1) Touch [Eject] of Disc on the Eject/Tilt screen and eject the disc. If not ejecting, consult your Alpine dealer. 2) When the error indication remains after ejecting, touch [Eject] of Disc on the Eject/Tilt screen again. If the error indication still does not turn off after trying to touch [Eject] of Disc on the Eject/Tilt screen. for a few times, consult your Alpine dealer. • Disc was forcibly pulled out by hand during Auto Loading. - When the error indication remains after loading, try to load again. If the error indication still does not turn off after pressing for a few times, consult your Alpine dealer. • Scratched disc, contaminated disc/poor recording/disc incompatible with this unit. - Touch [Eject] of Disc on the Eject/Tilt screen. - Change the disc. • A copy-protected WMA file was played back. - You can only play back non-copy-protected files. • A sampling rate/bit rate not supported by the unit is used. - Use a sampling rate/bit rate is supported by the unit. Indication for DVD/CD • No disc is inserted. - Insert a disc. • Although a disc is inserted, "No Disc" is displayed and the unit does not start to play or eject the disc. - Remove the disc by following these steps. Press for at least 3 seconds. 85-EN