Alpine PDR-F50 Owners Manual

Alpine PDR-F50 Manual

Alpine PDR-F50 manual content summary:

  • Alpine PDR-F50 | Owners Manual - Page 1
    EN AUTOMQVILES PDR-M65 MONO POWER AMPLIFIER I I PDR-FSO I 4 CHANNEL POWER AMPLIFIER • OWNER'S MANUAL Please read before using this equipment. • MODE D'EMPLOI Veuillez lire avant d'utiliser cet appareil. • MANUAL DE OPERACION Lealo antes de utilizar este equipo. ALPINE ELECTRONICS MARKETING
  • Alpine PDR-F50 | Owners Manual - Page 2
    on how to use this product in a safe and effective manner. Alpine cannot be responsible for problems resulting from failure to observe the instructions in this manual. ~WARNING This symbol means important instructions. Failure to heed them can result in serious injury or death. DO NOT
  • Alpine PDR-F50 | Owners Manual - Page 3
    symbol means important instructions. Failure to heed them can result in injury or property damages. HALT USE IMMEDIATELY IF A PROBLEM APPEARS. Failure to do so may cause personal injury or damage to the product. Return it to your authorized Alpine dealer or the nearest Alpine Service Center for
  • Alpine PDR-F50 | Owners Manual - Page 4
    -M65/ PDR-FSO, considerable heat is produced when the amplifier is in operation. For this reason, the amplifier should be mounted in a location which will allow for free circulation of air, such as inside the trunk. For alternate installation locations, please contact your authorized Alpine dealer
  • Alpine PDR-F50 | Owners Manual - Page 5
    ATTACHING THE TOP COVER AND LOGO PLATE 1. Attach the Top Cover after connections and confirmation of correct operation. 2. Peel the backing paper from the Logo Plate, then attach it to this unit in your desired direction. (Fig. 4) Backing Paper Logo Plate Fig. 4 4-EN
  • Alpine PDR-F50 | Owners Manual - Page 6
    CONNECTIONS .PDR-M65 • PDR-FSO Fig. 5 * Be sure to add an in-line fuse with the battery lead as close as possible to the battery's positive(+) terminal. Fig. 6 Before making connections, be sure to turn the power off to all audio components. Connect the battery lead from the amp directly to the
  • Alpine PDR-F50 | Owners Manual - Page 7
    correct channel connections; Left to Left and Right to Right. 0 Pre-Out Jacks (PDR-M65 only) These jacks provide a line level output. This is an ideal output for driving a second subwoofer amp. This output is full-range, and is not affected by the crossover. 0Fuse PDR-M65 35A x 2 PDR-F50 30A
  • Alpine PDR-F50 | Owners Manual - Page 8
    cables exceed 1 m, or if you connect more than one amplifier, a distribution block should be used. See below for wire gauge recommendations for distribution block connection to battery and ground (depends upon wire length necessary): PDR-M65/PDR-F50: 2 AWG (33 mm2) or 1/0 AWG (53 mm2) 2. Remove the
  • Alpine PDR-F50 | Owners Manual - Page 9
    . Otherwise, the amplifier will remain on and drain the battery. CD Blue/White ® Power Antenna @Remote Turn-On Lead QD To other Alpine component's Remote Turn-On Leads @ SPST Switch (optional) ®Fuse (3A) (j) As close as possible to the vehicle's ignition tap ®Ignition Source PDR-M65 PDR-FSO CD GV
  • Alpine PDR-F50 | Owners Manual - Page 10
    Gain Adjustment Control Set the PDR-M65/PDR-F50 input gain to the minimum position. Using a dynamic CD as a source, increase the head unit volume until the output distorts. Then, reduce the volume 1 step (or until the output is no longer distorted). Now, increase the amplifier gain until the sound
  • Alpine PDR-F50 | Owners Manual - Page 11
    4D Input Channel Selector Switch (PDR-FSO only) ~ 1/2 3/4 INPUT CHANNEL a) This switch setting is for selecting either 2-channel or 4-channel input mode Blue Red (blinking) Red Status Amplifier circuit is normal. Operating temperature is high. Amplifier circuit is abnormal. An electrical short
  • Alpine PDR-F50 | Owners Manual - Page 12
    fD Subwoofer G) Front Speakers G) Rear Speakers ~Head Unit, etc. ~ Front Output ~ Rear Output e~ Subwoofer Output RCA Extension Cable (Sold Separately) f) Y-Adapter (Sold Separately) .PDR-M65 TYPICAL SYSTEM CONNECTIONS 1 Subwoofer System 2 Subwoofer System {MONO) Fig. 14 Fig. 1S 11-EN
  • Alpine PDR-F50 | Owners Manual - Page 13
    • PDR-FSO TYPICAL SYSTEM CONNECTIONS 4 Speaker System (4-Channellnput) 1=-:Jtl Input Channel Selector Switch: 3/4 1/2 3/4 INPUT CHANNEL 8 L R L R 4 Speaker System (2-Channellnput) 'J2 Input Channel Selector Switch: 1/2 1/2 3/4 INPUT CHANNEL (L) f) Fig. 16 L R L R 12-EN (R) (L) f) Fig.
  • Alpine PDR-F50 | Owners Manual - Page 14
    (L) Fig. 18 Important Tips on Bridging an Amplifier NOTE: • Low output will result if only one channel input is used. TheY-adapter is not required if a stereo/mono pair 0line output is used to drive both inputs of the bridged amp. Proper connection X Improper connection Fig. 19 i T~~ ~ (One
  • Alpine PDR-F50 | Owners Manual - Page 15
    Control Input Select Input Sensitivity Crossover Equalizer Remote Level* General Input Impedance Preamp Output Dimensions Weight PDR·M6S PDR-FSO Per Channel, Ref: 4 0, 14.4 V Per Channel, Ref: 2 0, 14.4 V Bridged, Ref: 4 0, 14.4 V Ref: 10 W into 4 0 .. Ref: lOW into 2 0 Ref: Rated Power into
  • Alpine PDR-F50 | Owners Manual - Page 16
    ~LPINE® Verification Certificate PAs.::;;.·:, Date : 201 4. 0i • L b Model : PDR-F50 Load Impedance : 2 ohms Test Voltage : 14.4V D.C Serial : - ACTUAL TEST MEASUREMENT •TEST • SPECIFICATION Output Power(RMS) 125W min (Full range) •ACTUAL '8'1 w ALPINE ELECTRONICS, INC.
  • Alpine PDR-F50 | Owners Manual - Page 17
    . Vous serez tenu informe des nouveaux produits, des mises ajour logicielles (le cas echeant) , des promotions speciales et des informations concernant Alpine. L'enregistrement de votre produit vous donne par ailleurs Ia possibilite de gagner des dizaines de cadeaux, tels que cheques-cadeaux et
  • Alpine PDR-F50 | Owners Manual - Page 18
    negligence, usage inapproprie, mauvaise utilisation ou par le non-respect des instructions indiquees dans le manuel de l'utilisateur. a @ Les dommages dus INTERETS SONT LES FRAIS DE TRANSPORT DU PRODUIT VERS UN CENTRE DE SERVICE ALPINE, LA PEATE DE TEMPS DE L'ACHETEUR ORIGINAL, LA PEATE D'UTILISATION
  • Alpine PDR-F50 | Owners Manual - Page 19
    by over-driving the speaker (amplifier level is turned up and or failure to follow instructions contained in the Owner's manual. @ Damage caused Alpine Service Center or Alpine, Alpine will pay the return shipping charges. ®You should provide a detailed description of the problem(s) for which service
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19

FOR CAR USE ONLY
/POUR
APPLICATION AUTOMOBILE/PARA USO EN AUTOMQVILES
PDR-M65
MONO
POWER AMPLIFIER
PDR-FSO
4 CHANNEL POWER AMPLIFIER
• OWNER'S MANUAL
Please read before using this equipment.
MODE
D'EMPLOI
Veuillez lire avant d'utiliser cet appareil.
• MANUAL DE OPERACION
Lealo antes de utilizar este equipo.
ALPINE
ELECTRONICS
OF
U.K.
LTD.
Alpine House
ALPINE
ELECTRONICS
MARKETING, INC.
1-7, Yukigaya-Otsukamachi, Ota-ku,
Tokyo 145-0067,
JAPAN
Fletchamstead Highway, Coventry CV4
9TW,
U.K.
Phone: 03-5499-4531
ALPINE
ELECTRONICS
OF
AMERICA, INC.
19145 Gramercy Place, Torrance,
California 90501,
U.S.A.
Phone 1-800-ALPINE-1 (1-800-257-4631)
ALPINE
ELECTRONICS
OF
AUSTRALIA
PTY.
LTD.
161-165 Princes Highway, Hallam
Victoria 3803, Australia
Phone 03-8787-1200
ALPINE
ELECTRONICS
GmbH
Wilhelm-Wagenfeld-Str. 1-3,
80807
Munchen,
Germany
Phone 089-32 42 640
JElL
Moon
Hwa
Co.
18-6, 3Ga, Pil_dong,
Jung_gu,
Seoul, Korea
Phone 0870-33
33
763
ALPINE
ELECTRONICS
FRANCE
S.A.R.L.
(RCS
PONTOISE
B 338
101
280)
98,
Rue
de
Ia
Belle Etoile, Z.l. Paris Nord
II,
B.P.
50016, 95945 Roissy Charles
de
Gaulle
Cedex, France
Phone 01-48638989
ALPINE
ITALIA S.p.A.
Vi
ale
C.
Colombo
8,
20090 Trezza
no
Sui
Naviglio (MI), Italy
Phone 02-484781
ALPINE
ELECTRONICS
DE
ESPANA,
S.A.
Portal de Gamarra 36, Pabell6n,
32
01013 Vito ria (Aiava)-APDO 133, Spain
Phone 945-283588
Designed
by
ALPINE Japan
Printed in Korea
68-25285ZSS-A
(Y
_AS)
M35145230 10
I
I
I