Alpine SPX-137A Owners Manual
Alpine SPX-137A - Type-X Car Speaker Manual
 |
View all Alpine SPX-137A manuals
Add to My Manuals
Save this manual to your list of manuals |
Alpine SPX-137A manual content summary:
- Alpine SPX-137A | Owners Manual - Page 1
SPX-177A / SPX-137A Component 2-way Speaker System OWNER'S MANUAL Please read before using this equipment MANUEL DE L'UTILISATEUR Veuillez lire le présent manuel avant la mise en service du matériel. ALPINE ELECTRONICS, INC. Tokyo office ; 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan - Alpine SPX-137A | Owners Manual - Page 2
Points à respecter pour une utilisation sûre l Read this manual carefully before starting operation and use this system safely. We cannot be responsible for problems resulting from failure to observe the instructions in this manual. l This manual uses various pictorial displays to show how to use - Alpine SPX-137A | Owners Manual - Page 3
System Contents / Contenu du système For Woofer Mounting / Pour le montage du woofer 1. Speaker unit / Unité du haut-parleur x2 (SPX-177A) (SPX-137A st4.2x19mm x4 25. Speaker wire / Câble du haut parleur x2 For Network Mounting / Pour le montage du filtre 26. Crossover Network / Filtre de - Alpine SPX-137A | Owners Manual - Page 4
Table des matières Installation Woofer (SPX-177A 5 Woofer (SPX-137A 7 Tweeter 8 Crossover Network 11 System Connections Single Input 12 Bi-wire 12 Crossover Network Settings Introduction 13 System Type 1 14 System Type 2 16 Specifications General 19 Mechanical 19 Theil/Small parameters - Alpine SPX-137A | Owners Manual - Page 5
-177A) Woofer: Surface mount st4.2x25mm Installation (SPX-177A) Woofer : Montage en surface st4.2x25mm Notes: l Attach gasket tape as shown. l If spacer ring is used with grille, snap-fit tabs on spacer - Alpine SPX-137A | Owners Manual - Page 6
Factory/OEM custom fit st4.2x25mm M4x10mm M4x18mm M4x20mm Installation (SPX-177A) Woofer : Usine / montage personnalisé par le vehicle l Use M4x10mm for speaker to adapter (adapter only) l Use M4x18mm for speaker to adapter (adapter + spacer) l Use M4x20mm for speaker to adapter (adapter + spacer - Alpine SPX-137A | Owners Manual - Page 7
Notes: l Attach gasket tape as shown, then lock speaker into grille ring. l If spacer ring is used with grille, snap-fit tabs on spacer ring must be removed for proper fit. Woofer: Factory/stealth st4.2x25mm Installation (SPX-137A) Woofer : Montage en surface st4.2x25mm Remarques : l Attachez - Alpine SPX-137A | Owners Manual - Page 8
Installation Tweeter: Swivel-surface mount Installation Tweeter : Montage pivotant en surface st4.2x9.5mm st4.2x19mm st4.2x9.5mm st4.2x19mm Notes: l Before mounting, insert swivel retention cup into housing. Then rotate until achieving a positive lock using an appropriate tool (screwdriver, etc - Alpine SPX-137A | Owners Manual - Page 9
Installation Tweeter: Swivel-flush mount Installation Tweeter : Montage pivotant à niveau st4.2x9,5mm st4.2x9,5mm Notes: l Before mounting, insert swivel retention cup into housing. Then rotate until achieving a positive lock using an appropriate tool (screwdriver, etc.). l Insert complete swivel - Alpine SPX-137A | Owners Manual - Page 10
Installation Tweeter: Fixed-flush mount Installation Tweeter : Montage fixe à niveau st4.2x9.5mm st4.2x9.5mm Notes: l Insert fixed-flush cup with mounting clips first through opening. (Fig. 1) l Press mounting clips at center and secure with screw. (Fig. 2) l Make connections, then insert and - Alpine SPX-137A | Owners Manual - Page 11
Remove network cover, and mount as shown l Connect wires to terminal blocks accordingly. (see System Connection Diagrams section) l Make appropriate jumper settings using jumper puller tool (see Crossover Network Settings section) l Re-secure network cover. Remarques : l Enlevez le cache du filtre - Alpine SPX-137A | Owners Manual - Page 12
System Connections Single Input Connexions du système Entrée simple Bi-wire Input Entrée par bi-câblage Note: Signal link jumpers highlighted in black must be inserted for proper function of single input configuration. Wiring for connection of crossover network to amplifier is not included. - Alpine SPX-137A | Owners Manual - Page 13
between drivers in a speaker system has never been addressed successfully, and it is certainly not always possible to achieve optimum positioning or placement in every application. It is for this reason that Alpine has designed the most versatile and complex crossover network in the history - Alpine SPX-137A | Owners Manual - Page 14
Crossover Network Settings System Type 1 (default) Speaker Placement Description: In this system type, woofer and tweeter are mounted in for both the woofer and tweeter to achieve optimum performance. All component locations listed below are commonly available in most vehicles, but are meant - Alpine SPX-137A | Owners Manual - Page 15
Crossover Network Settings Configuration du filtre de voies System Type 1 Type de SPX-177A) (SPX-137A) (SPX-137A) Note: These simulations only illustrate the effect of each filter upon the input signal, and therefore do not represent the actual summed frequency response of the speaker system - Alpine SPX-137A | Owners Manual - Page 16
Crossover Network Settings System Type 2 Speaker Placement Description: In this system type, woofer and tweeter are mounted different locations and at different distances from the listener. Also of significance, is the fact that the tweeter is the nearest driver. All component locations listed below - Alpine SPX-137A | Owners Manual - Page 17
177A) Fonction de transfert du filtre (SPX-177A) (SPX-137A) (SPX-137A) Note: These simulations only illustrate the effect of each filter upon the input signal, and therefore do not represent the actual summed frequency response of the speaker system. Remarque : Ces simulations n'illustrent que - Alpine SPX-137A | Owners Manual - Page 18
18 - Alpine SPX-137A | Owners Manual - Page 19
Shape Surround Material and Type Speaker Weight Woofer Magnet Weight Magnet System Type Depth Cut-out diameter Thiele/Small ReDC Fs Qts Qms Qes Vas Sd Le Cms Mms Bl Sealed box Volume (Butterworth) SPX-177A SPX-137A Component 2-way speaker Component 2-way speaker 240/60 W 200/50 W 4 W 4 W 35 - Alpine SPX-137A | Owners Manual - Page 20
Designed by Alpine Electronics of America, Inc. Printed in Denmark by Team Lynderup
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
SPX-177A / SPX-137A
Component 2-way Speaker System
OWNER’S MANUAL
Please read before using this equipment
MANUEL DE L'UTILISATEUR
Veuillez lire le présent manuel avant la mise en service du matériel.
ALPINE ELECTRONICS, INC.
Tokyo office ; 1-1-8 Nishi Gotanda,
Shinagawa-ku, Tokyo 141-8501, Japan
Tel.: (03) 3494-1101
ALPINE ELECTRONICS OF AMERICA, INC.
19145 Gramercy Place, Torrance,
California 90501, U.S.A.
Tel.: 1-800-ALPINE1 (1-800-257-4631)
1-888-NAV-HELP (1-888-628-4357)
ALPINE ELECTRONICS OF CANADA, INC.
Suite 203, 7300 Warden Ave. Markham, Ontario
L3R 9Z6, Canada
Tel.: 1-800-ALPINE1 (1-800-257-4631)
ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD.
6-8 Fiveways Boulevarde Keysborough Victoria 3173,
Australia
Tel.: (03) 9769-0000
ALPINE ELECTRONICS GmbH
Kreuzerkamp 7-11 40878 Ratingen, Germany
Tel.: 02102-45 50
ALPINE ITALIA S.p.A.
Via C.Colombo 8, 20090 Trezzano
Sul Naviglio MI, Itary
Tel.: 02-48 47 81
ALPINE ELECTRONICS FRANCE S.A.R.L.
98, Rue De La Belle Etoile, Z.I. Paris Nord II B.P.50016
F-95945, Roissy, Charles De Gaulle Cedex, France
Tel.: 01-48 63 89 89
ALPINE ELECTRONICS OF U.K., LTD.
13 Tanners Drive, Blakelands,
Milton keynes MK14
5BU, U.K.
Tel.: 01908-61 15 56
ALPINE ELECTRONICS DE ESPANÃ, S.A.
Portal De Gamarra 36, Pabollón 32
01013 Vitoria(Alava)-Apdo. 133, Spain
Tel.: 34-45-283588