Amana AGR5330BA Installation Instructions
Amana AGR5330BA Manual
 |
View all Amana AGR5330BA manuals
Add to My Manuals
Save this manual to your list of manuals |
Amana AGR5330BA manual content summary:
- Amana AGR5330BA | Installation Instructions - Page 1
Location Requirements 4 Electrical Requirements 5 Gas Supply Requirements 6 INSTALLATION INSTRUCTIONS 7 Unpack Range 7 Install Anti-Tip Bracket 7 Make Gas Connection 8 Verify Anti-Tip Bracket Is Installed and Engaged 9 Level Range 10 Electronic Ignition System 10 Complete Installation 12 - Amana AGR5330BA | Installation Instructions - Page 2
tell you what can happen if the instructions are not followed. WARNING: If the information in this manual is not followed exactly, a fire or instructions. • If you cannot reach your gas supplier, call the fire department. - Installation and service must be performed by a qualified installer, service - Amana AGR5330BA | Installation Instructions - Page 3
foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. Anti-Tip Bracket To verify the - Amana AGR5330BA | Installation Instructions - Page 4
installer to check that the floor covering can withstand at least 200°F (93°C). ■ Use an insulated pad or ¼" (0.64 cm) plywood under range if installing range over carpeting. IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used - Amana AGR5330BA | Installation Instructions - Page 5
not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with - Amana AGR5330BA | Installation Instructions - Page 6
testing of the range must be conducted according to the manufacturer's instructions. See "Complete Connection the range. ■ Must include a shutoff valve: The supply line must be equipped with a manual : Conversion must be done by a qualified service technician. No attempt shall be made to convert - Amana AGR5330BA | Installation Instructions - Page 7
manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3.5 kPa/14" WCP). INSTALLATION INSTRUCTIONS Unpack Range the range to support the range when it is laid on its back. 5. Using 2 or more people, firmly grasp the range and - Amana AGR5330BA | Installation Instructions - Page 8
gas company personnel, and authorized service personnel. Failure to do so range using the following installation instructions. A B D C E F G H A. Pressure regulator connection fitting B. Use pipe-joint compound. C. Adapter D. Flexible connector E. Adapter F. Use pipe-joint compound. G. Manual - Amana AGR5330BA | Installation Instructions - Page 9
is the "ON" position. If the range does not work, verify that the valve is in the "ON" position. 3. Open the manual shutoff valve in the gas supply line. use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 6. Plug into a - Amana AGR5330BA | Installation Instructions - Page 10
without anti-tip bracket installed and engaged. Please reference the "Assistance or Service" section of the Use and Care Guide, or the cover or "Warranty" section of the User Instructions, to contact service. Level Range 1. Place a standard flat rack in oven. 2. Place level on the rack and check - Amana AGR5330BA | Installation Instructions - Page 11
If the low flame needs adjusting: 1. Turn control knob to the "LO" setting and remove control knob. 2. Insert a small flat-blade screwdriver into the valve stem. Turn the valve adjusting screw to obtain the smallest flame that will not go out when the control of a cold burner is quickly turned from - Amana AGR5330BA | Installation Instructions - Page 12
valve is in the "on" position. ■ Electrical supply is connected. ■ See "Troubleshooting" in the Use and Care Guide or User Instructions. 8. When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shutoff valve is open - Amana AGR5330BA | Installation Instructions - Page 13
in the same position. A A B A. Burner cap B. Burner 2. Locate LP gas orifice spuds for top burners in the bag containing literature included with the range. Three LP gas spuds are stamped "88" and one is stamped "96." 3. Remove Natural gas orifice spuds using a 7 mm combination wrench. 4. Install - Amana AGR5330BA | Installation Instructions - Page 14
tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. 1. Turn manual shutoff valve to the "closed" position. B A C A. Gas supply - Amana AGR5330BA | Installation Instructions - Page 15
in the same position. A A B A. Burner cap B. Burner 2. Locate Natural gas orifice spuds for top burners in the bag containing literature included with the range. Three Natural gas spuds are stamped "149" and one is stamped "165." 3. Remove the LP gas orifice spuds using a 7 mm combination wrench - Amana AGR5330BA | Installation Instructions - Page 16
racks, oven tray and flame spreader. Complete Conversion 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Turn the manual shutoff valve in the gas supply line to the open position. 3. Refer to the "Electronic Ignition System" section for proper
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
INSTALLATION INSTRUCTIONS
30" (76.2 CM) FREESTANDING GAS RANGES
Table of Contents
RANGE SAFETY
.............................................................................
2
INSTALLATION REQUIREMENTS
...............................................
3
Tools and Parts
............................................................................
3
Location Requirements
...............................................................
4
Electrical Requirements
...............................................................
5
Gas Supply Requirements
..........................................................
6
INSTALLATION INSTRUCTIONS
.................................................
7
Unpack Range
.............................................................................
7
Install Anti-Tip Bracket
................................................................
7
Make Gas Connection
.................................................................
8
Verify Anti-Tip Bracket Is Installed and Engaged
.......................
9
Level Range
...............................................................................
10
Electronic Ignition System
.........................................................
10
Complete Installation
.................................................................
12
GAS CONVERSIONS
...................................................................
12
LP Gas Conversion
....................................................................
12
Complete Conversion
................................................................
14
Natural Gas Conversion
............................................................
14
Complete Conversion
................................................................
16
W10620415D
IMPORTANT:
Save for local inspector's use.
Installer:
Leave installation instructions with the homeowner.
Homeowner:
Keep installation instructions for future reference.