Amana NED4600Y Installation Instruction
Amana NED4600Y Manual
 |
View all Amana NED4600Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Amana NED4600Y manual content summary:
- Amana NED4600Y | Installation Instruction - Page 1
DRYER INSTALLATION INSTRUCTIONS 29" WIDE MODELS - U.S.A. ONLY Para obtener acceso al manual . Table of Contents DRYER SAFETY 2 INSTALLATION REQUIREMENTS 4 Tools and Parts 4 Location Requirements Dryer 16 Complete Installation Checklist 16 Reverse Door Swing (Optional 17 Troubleshooting 19 - Amana NED4600Y | Installation Instruction - Page 2
DRYER SAFETY 2 - Amana NED4600Y | Installation Instruction - Page 3
3 - Amana NED4600Y | Installation Instruction - Page 4
Requirements" before purchasing parts. Mobile home installations require metal exhaust system hardware, available for purchase from the dealer from whom you purchased your dryer. For further information, please reference the "Assistance or Service" section of the "Use and Care Guide". If using - Amana NED4600Y | Installation Instruction - Page 5
floor to support the total weight (dryer and load) of 200 lbs. (90.7 kg). The combined weight of a companion appliance should also be considered. ■■ Level floor with maximum slope of 1" (25 mm) under entire dryer. (If slope is greater than 1" [25 mm], install Extended Dryer Feet Kit, Part Number - Amana NED4600Y | Installation Instruction - Page 6
qualified electrician determine that the ground path is adequate. Electrical Connection To properly install your dryer, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. ■■ If local codes do not permit the connection of a neutral - Amana NED4600Y | Installation Instruction - Page 7
legs into leg holes by hand, use a wrench to finish turning legs until diamond marking is no longer visible. Now stand the dryer on its feet. Slide the dryer until it is close to its final location. Leave enough room for electrical connection and to connect the exhaust vent. Electrical Connection - Amana NED4600Y | Installation Instruction - Page 8
Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. For 3-wire Power Supply Cord Connection, see page 9. For - Amana NED4600Y | Installation Instruction - Page 9
(B). Tighten screw. Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. 3-wire Power Supply Cord Connection Use where local codes - Amana NED4600Y | Installation Instruction - Page 10
3-wire connections. 3. Prepare your 4-wire cable for direct connection (251"mm) (127 5" mm) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 5" (127 mm) of outer covering from end of cable, leaving bare ground wire at 5" (127 mm). Cut 11/2" (38 - Amana NED4600Y | Installation Instruction - Page 11
screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with holddown screw. Now, go to "mm) (893m½m" ) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 31/2" (89 mm) of outer covering from end of cable. Strip - Amana NED4600Y | Installation Instruction - Page 12
block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with holddown screw. Now, go to Venting Requirements. Place hooked ends of remaining wires under outer terminal block - Amana NED4600Y | Installation Instruction - Page 13
performance and to avoid crushing and kinking. Flexible metal vent: (Acceptable only if accessible to clean) ■■ Must be fully extended and supported in final dryer location. ■■ Remove excess to avoid sagging and kinking that may result in reduced airflow and poor performance. ■■ Do not install in - Amana NED4600Y | Installation Instruction - Page 14
. Two close-clearance installations are shown. Refer to the manufacturer's instructions. A A. Dryer B. Elbow C. Wall D. Exhaust hood C D E F G call 1-800-807-6777 or visit us at www.whirlpoolparts.ca. Part Number Descriptions 8171587RP 0-5" Metal vent periscope 4396037RP 0"-18" Metal vent - Amana NED4600Y | Installation Instruction - Page 15
metal 27 ft. (8.2 m) 21 ft. (6.4 m) Vent must fit over the exhaust hood. Secure vent to exhaust hood with 4" (102 mm) clamp. Run vent to dryer location using straightest path possible. Avoid 90° turns. Use clamps to seal all joints. Do not use duct tape, screws, or other fastening devices that - Amana NED4600Y | Installation Instruction - Page 16
them. Complete Installation Checklist q Check that all parts are now installed. If there is an extra part, go back through steps to see what was "Dryer Use" in your "Use and Care Guide". q Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer. If the dryer will - Amana NED4600Y | Installation Instruction - Page 17
odor will go away. Reverse Door Swing (Optional) 29" Super Wide Side-Swing Door 3. Lift door off top screws Lift door until top screws in dryer cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of - Amana NED4600Y | Installation Instruction - Page 18
outer door panel to inner door panel so handle is on the side where hinges were just removed. Insert 4 door screws. Reattach door hinges to dryer door so that the larger hole is at the bottom of the hinge. 18 - Amana NED4600Y | Installation Instruction - Page 19
plugs into hinge holes on opposite side of dryer cabinet. Close door and check that door strike aligns with door catch. If it is needed, slide door catch left or right within slot to adjust alignment. Troubleshooting See the Use and Care Guide or visit our website and reference Frequently Asked - Amana NED4600Y | Installation Instruction - Page 20
W10514172A W10514174A-SP ®/™ ©2013 Whirlpool. All rights reserved. 01/13 Printed in U.S.A.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
W10514172A
W10514174A-SP
DRYER SAFETY
.........................................................................
2
INSTALLATION REQUIREMENTS
.............................................
4
Tools and Parts
......................................................................
4
Location Requirements
.........................................................
5
Electrical Requirements
........................................................
6
Install Leveling Legs
..............................................................
7
Electrical Connection
............................................................
7
VENTING
...................................................................................
13
Venting Requirements
.........................................................
13
Plan Vent System
.................................................................
14
Venting Kits
..........................................................................
14
Install Vent System
..............................................................
16
Connect Vent
........................................................................
16
Level Dryer
...........................................................................
16
Complete Installation Checklist
.........................................
16
Reverse Door Swing (Optional)
..........................................
17
Troubleshooting
...................................................................
19
ELECTRIC DRYER INSTALLATION INSTRUCTIONS
29" WIDE MODELS - U.S.A. ONLY
Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite:
www.whirlpool.com
Tenga listo su número de modelo completo. Puede encontrar el número de modelo y de serie dentro de la cavidad superior de la puerta.
Table of Contents