Amana NFW7300WW Use and Care - Page 8

Connect the inlet hoses to the washer IMPORTANT: Make sure that the flat washers have been placed into the hose couplings. CH 2. Slide drain hose onto washer connection. 3. Once drain hose is in place, release pliers. H. Hot water inlet C. Cold water inlet 1. Attach the hot water hose to the washer's hot (H) water inlet valve. Screw on coupling by hand until it is seated on the washer. 2. Attach the cold water hose to the washer's cold (C) water faucet. Screw on coupling by hand until it is seated on the washer. 3. Using pliers, tighten the couplings with an additional two-thirds turn. NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result. 4. Turn on the water faucets completely and check for leaks. NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates on the hoses for future reference. Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found. Connect the Drain Hose Remove drain hose from washer drum 1. Use locking pliers, squeeze hose clamp tabs together and insert over the end of drain hose. 4. Washer drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Laundry tub drain or standpipe drain Connect the drain hose form to the corrugated drain hose. A B A. Snap either end of the drain hose form to the drain hose at the point where the corrugation begins. B. Bend drain hose over drain hose form and snap into place. To keep drain water from going back into the washer ■ Use the drain hose form, and do not force excess drain hose into standpipe. Hose should be secure, but loose enough to provide a gap for air. ■ Do not lay excess hose on the bottom of the laundry tub. Floor drain You may need additional parts. See Floor drain under "Tools and Parts." 8