American Standard Cadet-3 Installation Instructions - Page 2
Caution: Do Not Use, Cone Washer With, Plastic Supply Line. - parts
UPC - 033056671351
View all American Standard Cadet-3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
6 7 For Tanks/Bowls using Speed Connect System (Tank mounting bolts pre-installed). BOLT CAP TANK MTG. BOLTS PREINSTALLED RUBBER GASKET CLOSET FLANGE WASHER NUT CLOSET BOLT INSTALL TOILET a. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor. ! CAUTION: DO NOT OVERTIGHTEN NUTS OR BASE MAY BE DAMAGED! b. Install caps on washers. (If necessary, cut bolt height to size before installing caps.) c. Smooth off the bead of sealant around base. Remove excess sealant. WASHER/ NUT COMBO INSTALL TANK a. Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washer/nut combo. b. With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface. * USE INCLUDED TOOL, NUT DRIVER, OR DEEP SOCKET RACHET. ! CAUTION: DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT! 8 INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions. 9b 9a Before continuing, determine the type of water supply connecation you have from the chart below and use the appropriate assembly parts required to properly reconnect the water supply. DO NOT use plumber's putty to seal these fittings. METAL / COPPER FLARED TUBING LOCK NUT CONE WASHER COUPLING NUT WATER SHUT-OFF METAL FLANGED TUBING METAL SPIRAL TUBING VINYL / BRAIDED CONNECTOR LOCK NUT EXISTING WASHER EXISTING COUPLING NUT LOCK NUT EXISTING CONE WASHER COUPLING NUT LOCK NUT COUPLING NUT WATER SHUT-OFF WATER SHUT-OFF WATER SHUT-OFF These parts must be used as illustrated to insure water-tight connection. Use of existing coupling nut may result in water leakage. Water supply tube or pipe must extend at least 1/2" inside threaded shank of valve (does not apply to flanged tubing). Use existing coupling nut and washer. CAUTION: DO NOT USE CONE WASHER WITH PLASTIC SUPPLY LINE. Use existing spiral cone washer. Fluidmaster cone washer may not seal completely on spiral type supply line. Captive cone washers already included. No additional washers needed. CAUTION: Overtightening of LOCK NUT or COUPLING NUT could result in breakage and potential flooding. With correct washers in place (see Step 9a), tighten COUPLING NUT 1/4 turn beyond hand tight. DO NOT OVERTIGHTEN. ! WARNING: Do not use plumber's putty, pipe dope, or any other sealant on the water supply connection to this tank. If the connection leaks after hand tightening, replace the supply line. If the connection continues to leak with the new supply line, replace the fill valve. Warranty is void if any type of sealant is used on the water supply connection. - 2 - 7 3 0110 2 - 10 0 Rev. K