Ariens Deluxe 30 Quick Start Guide

Ariens Deluxe 30 Manual

Ariens Deluxe 30 manual content summary:

  • Ariens Deluxe 30 | Quick Start Guide - Page 1
    Quick Start Guide Deluxe 30 Platinum (921029 s/n 000101 & up) • Step 1: Assemble Handlebars • Step 2: Install Discharge Chute • Step 3: Install Chute Control Assembly • Step 4: Install Discharge Chute Rod • Step 5: Install Remote Deflector Control • Step 6: Check Function of Dual Handle Interlock •
  • Ariens Deluxe 30 | Quick Start Guide - Page 2
    Step One: Assemble Handlebars NOTE: The Ariens company has made changes to packaging that affects this serial number range. If the upper handlebars on your unit came already attached please disregard the following five slides. Not attached Attached
  • Ariens Deluxe 30 | Quick Start Guide - Page 3
    block wheels or secure unit so it does not move during assembly. 1. Rotate lower handlebar out from unit so lower handlebar mounting holes align with mounting holes on the unit frame. 2. Secure lower handlebar to unit using two 3/8 in x 3/4 in. hex head serrated flange grade 5 bolts. 3. Tighten all
  • Ariens Deluxe 30 | Quick Start Guide - Page 4
    slide applies to UNATTACHED handlebars ONLY 1. Attach upper handlebar assembly to lower handlebar using two sets of the handlebar hardware. One set to attach each side of the handlebars. NOTE: DO NOT tighten hardware. Allow upper handlebar assembly to hang from the lower handlebars for the next
  • Ariens Deluxe 30 | Quick Start Guide - Page 5
    Step One: Assemble Handlebars (Attach Control Cables) NOTE: This slide applies to UNATTACHED handlebars ONLY 1. Hook spring end of attachment control cable to the clutch arm. 2. Hook spring
  • Ariens Deluxe 30 | Quick Start Guide - Page 6
    hardware attaching the upper handlebar assembly to the lower handlebar. 3. Tighten all hardware. 4. Remove packaging around shift rod. 5. Rotate Adjustment in the Owners Manual. 7. Adjust attachment cable as specified. See Attachment Clutch/Brake Adjustment in the Owners Manual. 8. Adjust the
  • Ariens Deluxe 30 | Quick Start Guide - Page 7
    (Connect Headlight Wire Harness) NOTE: The headlight wire harness comes attached to the upper handlebar assembly. 1. Route the wire harness along the interior of the right side handlebar. 2. Connect to the engine electrical plug. 3. Press cable anchor into mounting hole in the frame near the
  • Ariens Deluxe 30 | Quick Start Guide - Page 8
    Handlebar 1. Remove the lower and loosen the upper hardware on the handlebar assembly. 2. Loosen the hardware on the shift rod. 3. Put the speed selector lever in the sixth forward position. 4. Rotate the handlebar into operating position. NOTE: Be
  • Ariens Deluxe 30 | Quick Start Guide - Page 9
    Step Two: Install Discharge Chute 1. Grease underside of discharge chute ring (if not already greased). 2. Remove mounting hardware from auger housing. 3. Install discharge chute over opening in
  • Ariens Deluxe 30 | Quick Start Guide - Page 10
    Step Three: Install Chute Control Assembly 1. Remove the gear cover from top of chute pedestal. 2. Release the lock teeth on the gear assembly with your finger and rotate the discharge chute so it points straight ahead. NOTE: Make sure alignment markers are lined up when discharge chute is
  • Ariens Deluxe 30 | Quick Start Guide - Page 11
    from the control panel. 4. Make sure the chute control cable is routed between the lower handlebar and the bottom of the control panel, insert control assembly into slot in control panel from below and install assembly into nylon bushing in control panel. 5. Reinstall rubber grommet over control
  • Ariens Deluxe 30 | Quick Start Guide - Page 12
    the chute rod. 1. Insert chute rod end without ears into control lever and slide into control panel until opposite end of rod clears the gear assembly. 2. Align end of chute rod with hex hole in gear assembly and insert until ears hit gear. 3. Insert hairpin into hole in chute rod near gear
  • Ariens Deluxe 30 | Quick Start Guide - Page 13
    The chute control cable hook will prevent the cable from contacting the engine or muffler guard. Make sure the cable stays connected while unit is make sure the chute control cable ends are properly seated in control assembly and control arm. 6. Replace gear cover on top of chute Owner Manual.
  • Ariens Deluxe 30 | Quick Start Guide - Page 14
    from entering the cable. 6. Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary see Remote Deflector Control in Owners Manual.
  • Ariens Deluxe 30 | Quick Start Guide - Page 15
    Step Six: Check Function of Dual Handle Interlock Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches
  • Ariens Deluxe 30 | Quick Start Guide - Page 16
    Step Seven: Check Tire Pressure Check tire pressure and adjust to the pressure listed on tire sidewall.
  • Ariens Deluxe 30 | Quick Start Guide - Page 17
    Step Eight: Adjust Skid Shoes IMPORTANT: Skid shoes should be adjusted as conditions require. Allow 1/8 in. (3mm) between scraper blade and hard smooth surfaces. Allow 7/8 in (22 mm) between scraper blade and uneven or gravel surfaces. (See Skid Shoes in Owners Manual).
  • Ariens Deluxe 30 | Quick Start Guide - Page 18
    Step Nine: Check Auger Gearcase Oil Check oil level in auger gearcase (see Check Auger Gearcase in Owners Manual).
  • Ariens Deluxe 30 | Quick Start Guide - Page 19
    Step Ten: Check Engine Crankcase Oil (Ariens AX) IMPORTANT: The engine is shipped with 5W-30 oil in crankcase. Refer to engine manual for detailed instructions.
  • Ariens Deluxe 30 | Quick Start Guide - Page 20
    Step Eleven: Fill Engine Fuel Tank (Ariens AX) Fill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK in Owners Manual.
  • Ariens Deluxe 30 | Quick Start Guide - Page 21
    Step Twelve: Starting the Engine (Ariens AX)
  • Ariens Deluxe 30 | Quick Start Guide - Page 22
    Starting Engine / Step A: Choke Turn throttle all the way up. Turn choke ON.
  • Ariens Deluxe 30 | Quick Start Guide - Page 23
    Starting Engine / Step B: Rocker Switch Push rocker switch to RUN position.
  • Ariens Deluxe 30 | Quick Start Guide - Page 24
    Starting Engine / Step C: Fuel Shut Off Valve Turn fuel petcock to ON position.
  • Ariens Deluxe 30 | Quick Start Guide - Page 25
    Starting Engine / Step D: Key Install Safety Key Switch. Insert ignition key into slot but DO NOT turn the key. Be sure ignition key snaps into place.
  • Ariens Deluxe 30 | Quick Start Guide - Page 26
    Starting Engine / Step E: Prime Prime system: 3 primes maximum. DO NOT over prime system. Make sure to cover the vent hole on primer bulb before the primer bulb is compressed. Hold the primer bulb in the compressed position for one full second each time you press it. Repeat for a total of 3 primes.
  • Ariens Deluxe 30 | Quick Start Guide - Page 27
    Starting Engine / Step F: (Manual Start) Grasp rope handle. Pull slowly until resistance is felt, then pull rope firmly and quickly to start engine and avoid kickback.
  • Ariens Deluxe 30 | Quick Start Guide - Page 28
    Starting Engine / Step F: (Electric Start) Use a 3-wire extension cord and plug cord into starter motor adaptor first. Then plug cord into wall receptacle. Use appropriately sized extension cord (10AWG or larger) to prevent damage to electric starter.
  • Ariens Deluxe 30 | Quick Start Guide - Page 29
    Starting Engine / Step G: (Electric Start) Press and hold starter button. Note: Do not hold the electric starter button down for more than 5 seconds. Wait at least 1 minute before additional starting attempts.
  • Ariens Deluxe 30 | Quick Start Guide - Page 30
    Starting Engine / Step H: Warm up Allow the engine to warm up for 1-2 minutes, move the choke control to the CHOKE OFF position.
  • Ariens Deluxe 30 | Quick Start Guide - Page 31
    Step Thirteen: Stopping the Engine (Ariens AX) To stop engine in an emergency, flip the Rocker Switch to the STOP position, OR Pull Safety Key from Engine. Under normal conditions: 1. Turn throttle down. 2. Push rocker switch to STOP position. 3. Pull safety key OUT.
  • Ariens Deluxe 30 | Quick Start Guide - Page 32
    Additional Resources • Refer to Owners Manual and Engine Manual • Contact Ariens Company www.ariens.com Phone: 920-756-4688 E-mail: [email protected] 2013 The Ariens Company. All rights reserved.
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

Quick Start Guide
Deluxe 30 Platinum (921029 s/n 000101 & up)
Step 1: Assemble Handlebars
Step 2: Install Discharge Chute
Step 3: Install Chute Control Assembly
Step 4: Install Discharge Chute Rod
Step 5: Install Remote Deflector Control
Step 6: Check Function of Dual Handle Interlock
Step 7: Check Tire Pressure
Step 8: Adjust Skid Shoes
Step 9: Check Auger Gearcase Oil
Step 10: Check Engine Crankcase Oil
Step 11: Fill Engine Fuel Tank
Step 12: Start Engine
Step 13: Stop Engine
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
IMPORTANT:
READ OPERATOR’S MANUAL AND ENGINE MANUAL
THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES
BEFORE OPERATING.