Asko D5233 User manual Use & Care Guide Asko D5233 EN - Page 20

Rinse aid Adding rinse aid In some cases, drying can be made more efficient by using rinse aid. Machines with indicator on the panel When the rinse aid has run out and more is needed, the rinse aid symbol on the panel lights up*. To fill with rinse aid: 1. Turn and lift up the cover of the rinse aid compartment to the right of the dispenser. This is where you top up and set the amount of rinse aid to be dispensed in each wash. 2. Carefully pour in rinse aid up to the dosage setting knob. Alter dosage if required. Do not forget to close the cover. *Note! After filling there may be a short delay before the signal light goes out. Select dosage The dispenser is usually set at 1= soft water. However, depending on the water hardness, you may need to change the dosage. Open the rinse aid cover. Here you will find the dispenser's adjustment dial. Settings 1-6: the harder the water, the higher the dosage. When the water hardness exceeds 3 grains, you should use rinse aid with citric acid (acid rinse aid). Too much rinse aid can lead to the buildup of foam. If your water is particularly soft, you can dilute the rinse aid (1 part rinse aid, 1 part water). Too much rinse aid can cause streaks on the dishes, while too little can result in water stains. Machines with refill indicator in detegrent dispenser There is a refill indicator in the middle of the dispenser (see illustration). If the refill indicator is totally black, there is sufficient rinse aid. However, if the indicator has a more transparent appearance, you need to top up with rinse aid (see above). Refill indicator Open Closed Cover for rinse aid Open by turning and lifting the cover! 20 Customer Care Center 1-800-898-1879 www.askousa.com