Asko T753C User manual 8090243 Asko T753C AE - Page 25

Installation instructions Connecting a 3-wire Power Cord WARNING! Before starting this procedure, be sure the power is turned off at the breaker/fuse box. Ground Ground (center) 5. Connect ground (center) wire of power supply cord to the center, silver-colored terminal screw. Tighten screw. 6. Connect the other wires to outer screws. 7. Tighten the strain relief screws. 8. Replace terminal box cover on back of dryer. 9. Plug dryer into wall receptacle. 10. Turn power on at breaker/fuse box. Connecting a 4-wire Power Cord WARNING! Before starting this procedure, be sure the power is turned off at the breaker/fuse box. Power Supply Cord You will need a 3-wire power supply cord with three No. 10 copper wires and a matching 3-wire receptacle of NEMA Type 10-30R, as illustrated below: To connect a 3-wire power cord to the dryer, follow the steps below. NOTE! The numbers in the illustration below correlate to the step numbers. 1. Turn the power off at the breaker or fuse box. 2. Remove terminal block cover. 3. Use the strain relief attached below the terminal block opening. 4. Loosen or remove center terminal block screw. Power Supply Cord You will need a 4-wire power supply cord with four No. 10 copper wires and a matching 4-wire receptacle of NEMA Type 14-30R, as illustrated below. The fourth wire must be identified with a white cover and the ground conductor by a green cover. To connect a 4-wire power cord to the dryer, follow the steps below. NOTE! 4 The numbers in the illustration below correlate to the step numbers. 1. Turn the power off at the breaker/fuse box. 5 2. Remove terminal block cover. 6 3. Use the strain relief attached below the terminal block opening. 4. Remove center terminal block screw. Customer Care Center 25 1-800-898-1879 www.askousa.com