Asko W6761 User manual General Use & Care Guide EN - Page 14
Changing Temperature, Readout From Celsius To, Fahrenheit, Programming Child-safe, Start/stop, W6441 - f3
View all Asko W6761 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
cancelled after the main wash has started. NOTE: The Wool and Hand/Delicate wash programs automatically have a higher water level. Anti-Crease Button This option is designed to reduce wrinkling of garments that are not going to be taken out of the washer right away. When you select Anti-crease, the drum will rotate once every minute at the end of the program for two hours or until you press the Door Open button. The indicator light will stay lit when this option is on. To cancel this option, hold down the button until the indicator light goes off. This option cannot be cancelled after you have started the program. CHANGING TEMPERATURE READOUT FROM CELSIUS TO FAHRENHEIT You can change the temperature readout on the LED from Celsius to Fahrenheit and vice versa. To do this, follow the steps below: 1. Turn the machine off then on again. (00 should show on the display.) 2. Press the Start button five times in succession then press the Temperature button five times. (This must be done within 15 seconds.) The LED will display a C or F, whichever is the current selection. 3. Within three seconds, press the Temperature button again to change the readout. PROGRAMMING CHILD-SAFE START/STOP You can program the washer not to start unless the Start button is held down for three seconds. This is to prevent children from inadvertently starting the machine. To program this function, follow the steps below: 1. Turn the machine off then on again. (00 should show on the display.) 2. Press the Start button five times in succession then press the Spin Speed button five times. (This must be done within 15 seconds.) 3. Within three seconds, press the Spin Speed button again to select Child-safe start. The LED will display "3" to indicate the Child-safe function is active. (If the child-safe start has already been activated, "0" will display after you press the Spin Speed button.) W6441 ERROR MESSAGES Error messages will display on the LED if faults occur while a program is in progress. The table below defines each possible error message. To remove the message, turn the power off or change the program. MESSAGE 0000 FI F2 F3 F4 F5 F6 F8 ERROR When this symbol flashes on the LED it merely means the glass door isn't closed securely. Close the door and try again. If this message flashes on the LED, the machine has failed to spin. This could be because the load is out of balance. Turn the power off then on again. Open the door and redistribute the washing. Run the Spin program again. This indicates an overflow has occurred. Call a service technician. This indicates a problem with the motor. Call a service technician. This indicates a problem with the drain pump. Refer to the Troubleshooting chapter for possible solutions. This indicates a problem with the water inlet. Refer to the Troubleshooting chapter for possible solutions. This indicates a problem with the thermistor. Call a service technician. This indicates a temperature stop fault. Call a service technician. This indicates a door opening fault. Call a service technician. Page 14