Asus P5LD2 SE Motherboard Installation Guide - Page 86

Hyper Path 3 [Auto] Allows you to enable or disable the ASUS Hyper Path 3 feature. Configuration options: [Disabled] [Enabled] [Auto] DRAM Throttling Threshold [Auto] Allows you to set DRAM throttling threshold to auto or disabled. Configuration options: [Disabled] [Auto] Boot Graphic Adapter Priority [PCI Express/PCI] Allows selection of the graphics controller to use as primary boot device. Configuration options: [PCI Express/PCI] [PCI/PCI Express] PEG Buffer Length [Auto] Sets the length of the PCI Express graphics card buffer. Configuration options: [Auto] [Long] [Short] Link Latency [Auto] Sets the PCI Express graphics card link latency. Configuration options: [Auto] [Slow] [Normal] PEG Root Control [Auto] Allows you to enable, disable, or set to automatic the PCI Express graphics card root control. Configuration options: [Auto] [Disabled] [Enabled] PEG Link Mode [Auto] Sets the PCI Express graphics link mode. Setting this item to [Auto] allows the motherboard to automatically adjust the PCI Express graphics link mode to the correct frequency based on the system configuration. Four additional settings are available for overclocking the PEG Link Mode. Configuration options: [Auto] [Slow] [Normal] [Fast] [Faster] Slot Power [Auto] Sets the PCI Express graphics card slot power. Configuration options: [Auto] [Light] [Normal] [Heavy] [Heavier] High Priority Port Select [Disabled] Allows you to disable or select the high priority port. The specified high priority port will be given arbitration above VC0 but below VC1. Configuration options: [Disabled] [PCI Express Port 4] 4-26 Chapter 4: BIOS setup