Audiovox 07S3BP User Guide
Audiovox 07S3BP - Car Transmitter For APS57A Manual
 |
UPC - 044476058301
View all Audiovox 07S3BP manuals
Add to My Manuals
Save this manual to your list of manuals |
Audiovox 07S3BP manual content summary:
- Audiovox 07S3BP | User Guide - Page 1
Model 07S3BP Transmitter Programming Guide These transmitters makes use of icons (symbols) to add transmitters, please follow the programming instructions listed on the pages of this manual. BUTTON RECEIVER CHANNEL SYSTEM FUNCTION 1 Lock And Arm Alarm, also initiate and terminates *Panic - Audiovox 07S3BP | User Guide - Page 2
car starter AS 9153 Remote window roll up AS 9256 Remote trunk release relay Although the most common use of the transmitter buttons are shown on the front page of this guide . Non alarm models will flash alarm module is capable of this feature, simply complete step 4 of these programming instructions - Audiovox 07S3BP | User Guide - Page 3
4) Press and hold the lock or lock/unlock symbol button of the transmitter you wish to program for 4 seconds or until a long chirp is heard from the siren. "Repeat step 4 for each transmitter you wish to program". NOTE: If your transmitter button has the Lock/Unlock icon on one button, press and - Audiovox 07S3BP | User Guide - Page 4
(Repeat this for each transmitter you wish to operate the Channel 6 output, Driver Priority 1) 15. Within 10 seconds, press and release the valet program switch one time. (Siren emits 7 short chirps indicating channel 7 has been entered) 16 .Within 10 Seconds, Press and hold the unlock button (or - Audiovox 07S3BP | User Guide - Page 5
the rear of the case. 2) Remove the rear cover to access the discharged battery paying attention to the proper polarity orientation. 3) Carefully remove and properly dispose of the discharged battery. 4) Insert the new battery, being certain the metal key ring bar is in it's proper location, close - Audiovox 07S3BP | User Guide - Page 6
Remove the #0 Phillips head screws where indicated to gain access to the CR2032 battery. Carefully remove transmitter back cover keeping hold of the metal key ring to prevent it's loss. Carefully remove the discharged battery by sliding it out from under the clip in the direction indicated by the - Audiovox 07S3BP | User Guide - Page 7
to the instructions below. Indicate the pad number of your transmitter selected from the pads shown above. Note: Transmitter model number found on - 800 - 645 - 4994, and follow the instructions from the operator interface. Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y., 11788 - Audiovox 07S3BP | User Guide - Page 8
© 2007 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY, 11788 128-8112 8 128-8112 8 of 8
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
128-8112
1 of 8
1
2
1
3
3
*4
*5
BUTTON
RECEIVER
CHANNEL
SYSTEM FUNCTION
Lock And Arm Alarm, also initiate and
terminates *Panic
Unlock And Disarm, also initiates and
terminates
*Panic.
Programmable to
unlock drivers door and or all doors.
Lock and arm/unlock and disarm.
May
be programmed to unlock driver's door
or all doors. Also will initiate and
terminate *Panic.
Pulsed or switched output to control
Remote Trunk Release or optional
device connected to channel 3.
When pressed and release two times,
will provide pulsed output or activate the
Remote Start option when installed.
When so equipped, this button can be
used to operate an optional device
connected to channel 4.
When so equipped, this button can be
used to operate an optional device
connected to channel 5.
These transmitters makes use of icons (symbols) to identify the reac-
tion your security system/keyless entry/and or remote start system,
where applicable, will have when any icon (button) is pressed.
These icons are programmed at time of installation to meet the needs of
the individual and to complement the vehicle that the system is installed
in.
To replace a transmitter or add transmitters, please follow the
programming instructions listed on the pages of this manual.
Transmitter Programming Guide
* Where So Equipped
Model 07S3BP