Audiovox 07SP Programming Manual
Audiovox 07SP - Remote 434MHz Transmitter Manual
 |
UPC - 044476058295
View all Audiovox 07SP manuals
Add to My Manuals
Save this manual to your list of manuals |
Audiovox 07SP manual content summary:
- Audiovox 07SP | Programming Manual - Page 1
the individual and to complement the vehicle that the system is installed in. To replace a transmitter or add transmitters, please follow the programming instructions listed on the pages of this manual. BUTTON RECEIVER CHANNEL SYSTEM FUNCTION 1 Lock And Arm Alarm, also initiate and terminates - Audiovox 07SP | Programming Manual - Page 2
unused Option Buttons of your transmitter are: AS 9075 Remote car starter AS 9153 Remote window roll up AS 9256 Remote trunk release relay Although the most common use of the transmitter buttons are shown on the front page of this guide, any button or button combination can be programmed into any - Audiovox 07SP | Programming Manual - Page 3
or until a long chirp is heard from the siren. "Repeat step 4 for each transmitter you wish to program". Note: If your transmitter button has the Lock/Unlock icon on one button, press and release the valet push button switch 2 times then move on to step #8. 5) Press and release the valet push - Audiovox 07SP | Programming Manual - Page 4
used as a separate output to control a function other than driver priority. Simply programming any unused transmitter button other than the unlock button will allow complete independent control of these outputs. ERASING TRANSMITTERS IF THEY HAVE BEEN LOST OR STOLEN: Note: Before you begin to erase - Audiovox 07SP | Programming Manual - Page 5
. If the button is released and not pressed again within the 5 second period, no change in programming has been made to the receiver channel. The programmer can move onto a different channel or erase the transmitter codes as described in 1 above. BATTERY REPLACEMENT: The transmitter incorporates - Audiovox 07SP | Programming Manual - Page 6
Remove two #0 Phillips head screws where indicated to gain access to the CR 2032 battery. Carefully remove transmitter back cover keeping hold of the metal key ring to prevent it's loss. Carefully remove the discharged battery by sliding it out from under the - Audiovox 07SP | Programming Manual - Page 7
8) Mail this form along with your payment to: Credit card purchasers can order additional or replacement transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface. Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y., 11788 Attn - Audiovox 07SP | Programming Manual - Page 8
© 2007 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY, 11788 128-8119 8 128-8119 8 of 8
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
128-8119
1 of 8
1
2
1
3
3
*4
*5
BUTTON
RECEIVER
CHANNEL
SYSTEM FUNCTION
Lock And Arm Alarm, also initiate and
terminates *Panic
Unlock And Disarm, also initiates and
terminates
*Panic.
Programmable to
unlock drivers door and or all doors.
Lock and arm/unlock and disarm.
May
be programmed to unlock driver's door
or all doors. Also will initiate and
terminate *Panic.
Pulsed or switched output to control
Remote Trunk Release or optional
device connected to channel 3.
When pressed and release two times,
will provide pulsed output or activate the
Remote Start option when installed.
When so equipped, this button can be
used to operate an optional device
connected to channel 4.
When so equipped, this button can be
used to operate an optional device
connected to channel 5.
These transmitters make use of icons (symbols) to identify the reaction
your security system/keyless entry/and or remote start system, where
applicable, will have when any icon (button) is pressed. These
icons are programmed at time of installation to meet the needs of the
individual and to complement the vehicle that the system is installed in.
To replace a transmitter or add transmitters, please follow the
programming instructions listed on the pages of this manual.
Transmitter Programming Guide
* Where So Equipped
Model 07S