Audiovox APS2K4SBCF50 Programming Manual

Audiovox APS2K4SBCF50 - Car Transmitter For APS686/APS786 Manual

Audiovox APS2K4SBCF50 manual content summary:

  • Audiovox APS2K4SBCF50 | Programming Manual - Page 1
    the needs of the individual and to complement the vehicle that the system is installed in. To replace a transmitter or add transmitters, please follow the programming instructions listed on the pages of this manual. BUTTON RECEIVER CHANNEL SYSTEM FUNCTION 1 Lock And Arm Alarm, also initiate and
  • Audiovox APS2K4SBCF50 | Programming Manual - Page 2
    (APS-2K4S only) AS 9075 Remote car starter AS 9153 Remote window roll up AS 9256 Remote trunk release relay Although the most common use of the transmitter buttons are shown on the front page of this guide, any button or button combination can be programmed into any receiver channel. Additionally
  • Audiovox APS2K4SBCF50 | Programming Manual - Page 3
    advance to channel 2. The siren will chirp 2 times and the dash mounted LED will Flash 2 times, indicating that the unit is ready to accept programming for channel # 2 which is only used for separate lock and unlock button transmitters, and is the disarm/unlock/unlock 2 and panic. 6) Press and hold
  • Audiovox APS2K4SBCF50 | Programming Manual - Page 4
    is heard. If a single chirp or multiple chirps, (up to 7 chirps), are heard, the unit is indicating that the transmitter has already been programmed elsewhere in the receiver. Release the transmitter button and within 5 seconds press and hold until a long chirp is heard. This action forces the unit
  • Audiovox APS2K4SBCF50 | Programming Manual - Page 5
    This is a bright high intensity LED which should not be directed toward or into the eyes of anyone. QUICK REFERENCE CHART: You can program any individual channel without reprogramming all channels. To go directly to a particular receiver channel follow the chart below: CHANNEL 1 Ign. On Then 2 Ign
  • Audiovox APS2K4SBCF50 | Programming Manual - Page 6
    Credit card purchasers can order additional or replacement transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface. Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y., 11788 Attn.: TRANSMITTER DEPARTMENT 6 128-6516A 6 of 8
  • Audiovox APS2K4SBCF50 | Programming Manual - Page 7
    THIS PAGE LEFT BLANK INTENTIONALLY 7 128-6516A 7 of 8
  • Audiovox APS2K4SBCF50 | Programming Manual - Page 8
    © 2006 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY, 11788 128-6516A 8 128-6516A 8 of 8
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

128-6516A
1 of 8
1
2
1
3
3
4
5
BUTTON
RECEIVER
CHANNEL
SYSTEM FUNCTION
Lock And Arm Alarm, also initiate and
terminates *Panic
Unlock And Disarm, also initiates and
terminates
*Panic.
Programmable to
unlock drivers door and or all doors.
Lock and arm/unlock and disarm.
May
be programmed to unlock driver's door
or all doors. Also will initiate and
terminate *Panic.
Pulsed or switched output to control
Remote Trunk Release or optional
device connected to channel 3.
When pressed and release two times,
will provide pulsed output or activate the
Remote Start option when installed.
When so equipped, this button can be
used to operate an optional device
connected to channel 4.
When so equipped, this button can be
used to operate an optional device
connected to channel 5.
These transmitters makes use of icons (symbols) to identify the reac-
tion your security system/keyless entry/and or remote start system,
where applicable, will have when any icon (button) is pressed.
These icons are programmed at time of installation to meet the needs of
the individual and to complement the vehicle that the system is installed
in.
To replace a transmitter or add transmitters, please follow the
programming instructions listed on the pages of this manual.
Transmitter Programming Guide
* Where So Equipped
Model APS-2K4, APS-2K4S,
APS-2K4MS, APS-2K4SFL
& APS-2K4MSFL
Rev A to show make mention of PBLED & APS
-
2K4SFL