Audiovox SIRCK2 Installation Guide
Audiovox SIRCK2 - Satellite Radio Receiver Manual
 |
UPC - 044476015014
View all Audiovox SIRCK2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Audiovox SIRCK2 manual content summary:
- Audiovox SIRCK2 | Installation Guide - Page 1
SHUTTLE Vehicle Installation Guides SIR-CK1 and SIR-CK2 Revision A: Changed the Switching Box Part Number to SIR-SWB 9/29/03. Revision B: Corrected Part Number for DC Power Adapter (112B3294) and added pages for formatting purposes 2/9/04. Rev C: Changed antenna part number and CK2 part number4-7- - Audiovox SIRCK2 | Installation Guide - Page 2
as the Audiovox Home kit or Vehicle/ Boat Kit as required by your specific installation needs. These kits are available at retailers where Audiovox main units are sold. Audiovox Home Kit: SIR-HK1 Audiovox Vehicle Kit: SIR-CK1 (With FM Modulator) Audiovox Vehicle Kit: SIR-CK2 (Without FM Modulator - Audiovox SIRCK2 | Installation Guide - Page 3
to detract from safe driving practices; remember that you are responsible as the vehicle operator to adhere to all safe driving and traffic regulations. 4. This unit not installed in accordance with these instructions, it could cause harmful interference to radio or television reception. If this - Audiovox SIRCK2 | Installation Guide - Page 4
Contents SIR-CK1 and SIR-CK2 Install Manual Base Audio Cable P/N 1286813C P/N 136C3484 P/N 112B3293 HARDWARE KIT - P/N 150-1519 Split Lock Washer, M4 Phillips Machine Screw (M4 x 8mm) 1 pc. Antenna P/N 118C1130 1 pc. DC Power Adapter P/N 112B3294 1 pc. 1 pc. 1 pc. Cradle CK1 P/N - Audiovox SIRCK2 | Installation Guide - Page 5
Sirius® Satellite Radio as soon as the Shuttle and Vehicle Kit installation are complete. Set up your Audiovox Shuttle using the following installation instructions normally. b. Locate a firm, reasonably flat surface within your car to permit optimum viewing and line-of-sight access by the supplied - Audiovox SIRCK2 | Installation Guide - Page 6
Interconnect Diagram SHUTTLE CRADLE CK1 OR CK2 AUDIO CABLE Interconnect Diagram FM Option FM FREQUENCY SELECTION SWITCH. SELECT 1 OF 4 AVAILABLE FREQUENCIES AND SET YOUR EXISTING CAR RADIO TO THE SAME FREQUENCY. VEHICLE FM RADIO VEHICLE RADIO ANTENNA SHUTTLE CRADLE CK1 ONLY ANT SHUTTLE - Audiovox SIRCK2 | Installation Guide - Page 7
impair your vision, block air bag(s) or obstruct vehicle dashboard controls and/or radio CD/casette operational displays. NOTE: The adhesive backing to prevent unintentional damage. c. Using the alcohol swab supplied with your kit, clean the mounting surface and thoroughly wipe the area dry with a - Audiovox SIRCK2 | Installation Guide - Page 8
, it may be beneficial to warm the adhesive backing on the base using a portable hair dryer, or by holding the backing surface in front of a vehicle heater vent. i. Remove the plastic liner from the adhesive backing on the base, and fix the base in position on the surface; make sure the - Audiovox SIRCK2 | Installation Guide - Page 9
vehicle-specific aftermarket brackets, such as those purchased separately from Panavise, Pro-Fit, etc. 5. Installing the Shuttle into the Cradle a. Remove the 3/4" x 3" double-sided tape from the supplied kit are lined up; use the RF connector as a guide. Then gently press in on the bottom of the - Audiovox SIRCK2 | Installation Guide - Page 10
your car radio when tuned to one of 6. Sirius CK2 cradle, the audio signal AUDIO OUT can be routed through an audio cable which is DC 12V applied to the auxiliary inputs of a radio or ANT entertainment system. 2. When using the CK1 cradle, the audio signal can be transmitted to a car radio - Audiovox SIRCK2 | Installation Guide - Page 11
the antenna at the preferred location on the roof or trunk surface. If the vehicle is equipped with a roof or trunk rack, the antenna may have to be . c. Apply power to the Shuttle system as outlined in the associated User Guide and obtain an audio output. If no audio is heard, first check the - Audiovox SIRCK2 | Installation Guide - Page 12
taking advantage of existing cable conduits. Then snake the cable around the passenger compartment to the back of the Sirius cradle. h. In SUV's, minivans, etc., route the cable into the vehicle under the rubber molding of the hatch door or tailgate, and then under the interior trim. NOTE: Avoid - Audiovox SIRCK2 | Installation Guide - Page 13
receptacle. The integral power LED of the power button ( ) will light red. j. You are now ready to enjoy Sirius programming within your vehicle. CAUTION: You could drain the vehicle battery if the cigarette lighter adapter remains plugged in after the ignition is turned off. Unplug the adapter to - Audiovox SIRCK2 | Installation Guide - Page 14
THIS PAGE LEFT BLANK INTENTIONALLY -14- 128-6813D 14 of 16 - Audiovox SIRCK2 | Installation Guide - Page 15
or noise, to correction of antenna problems, to costs incurred for installation, tapes, compact discs, speakers, accessories, or vehicle electrical systems. This Warranty does not apply rights which vary from state to state. U.S.A. : AUDIOVOX CORPORATION, 150 MARCUS BLVD., HAUPPAUGE, NEW YORK 11788 - Audiovox SIRCK2 | Installation Guide - Page 16
© 2004 Audiovox Electronics Corporation 128-6813D 128-6813D 16 of 16
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
128-6813D
1 of 16
Vehicle Installation Guides
SIR-CK1 and SIR-CK2
SHUTTLE
Revision A: Changed the Switching Box Part Number to SIR-SWB 9/29/03.
Revision B: Corrected Part Number for DC Power Adapter (112B3294)
and added pages for formatting purposes 2/9/04.
Rev C: Changed antenna part number and CK2 part number4-7-04.
Rev D: Changed cradle and shuttle connector and image 4-27-04.