Behringer DIGITAL DELAY DD600 Manual
Behringer DIGITAL DELAY DD600 Manual
 |
View all Behringer DIGITAL DELAY DD600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Behringer DIGITAL DELAY DD600 manual content summary:
- Behringer DIGITAL DELAY DD600 | Manual - Page 1
DIGITAL DELAY DD600 Digital Stereo Delay/Echo Effects Pedal Thank you for showing your confidence in us by purchasing the BEHRINGER DIGITAL DELAY DD600. This digital Delay effects pedal is designed to deliver 24-bit high-resolution stereo delay sounds comparable to state-of-the-art studio - Behringer DIGITAL DELAY DD600 | Manual - Page 2
DIGITAL DELAY DD600 Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included). The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be careful not to
-
1 -
2
 |
 |
(1)
Select the effect mode via the
MODE
switch (see table below).
(2)
Use the
D.TIME
control to fine-tune the
delay time. The delay time describes
how fast the signal repetitions will
follow after the original signal.
Depending on the selected mode,
you can adjust it between 1 ms and
2000 ms. In HOLD and TEMPO modes,
D.TIME is disabled.
(3)
The
F.BACK
(feedback) control adjusts
the amount of signal repetitions.
In HOLD mode, F.BACK is disabled.
(4)
LEVEL
adjusts the effect level.
(5)
Use the ¼" TS
IN
connector to plug in
the instrument cable.
(6)
Use the ¼" TS
TEMPO
connector to
connect an external foot switch.
Use the foot switch to tap in the song
tempo (in TEMPO MODE).
(7)
The ¼" TS
OUT A
connector sends a mono signal to your amp. In E/D mode, it sends the
effect signal only.
(8)
Use the
PAN OUT
connector and OUT A to acheive a full stereo delay effect. In E/D mode,
it sends the dry signal only.
(9)
The
ON/BATT
LED illuminates when the effect is activated. It also serves as a battery level indicator.
(10)
Use the foot switch to activate/deactivate the effect. In HOLD mode, use the foot switch to start
and stop the recording. The signal is recorded while holding down the foot switch. Playback begins
immediately after releasing it.
DIGITAL DELAY DD600
Digital Stereo Delay/Echo Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER DIGITAL DELAY DD600.
This digital Delay effects pedal is designed to deliver 24-bit high-resolution stereo delay sounds
comparable to state-of-the-art studio processors. Thanks to its parameter controls, you’ll have
plenty of cool sounds at your disposal to handle every situation.
1.
Controls
(4)
(8)
(9)
(1)
(5)
(10)
(3)
(2)
(7)
(6)
MODE
Effect Description
D.Time
1
DELAY
Short delay
1-50 ms
2
Short to medium delay
50-200 ms
3
Medium to long delay
200-800 ms
4
Long delay
800-2000 ms
5
HOLD
Record and playback your performance
(Rec.time: max.2 s)
6
REVERSE
Signal is repeated in reverse
1000-2000 ms
7
E/D
Stereo delay using OUT A and PAN OUT
1-400 ms
8
TEMPO
Adds a quarter note
D.TIME disabled.
Tap tempo via external foot switch
9
Adds
an eighth note
10
Adds a dotted eighth note
11
Add a triplet