Behringer EQ700 Manual

Ultimate 7-Band Graphic Equalizer

Thank you for showing your confidence in us by purchasing the BEHRINGER GRAPHIC EQUALIZER EQ700.

This high-quality stompbox is specifically designed to provide complete tone control and eliminate

unwanted feedback. It allows 7-band sound shaping and feedback elimination from 100 Hz to 6.4 kHz

with a powerful 15 dB boost/cut per band.

1.

Controls

(1)

The

7-band EQ

faders allow to boosting/cutting single frequency ranges from

100 Hz to 6.4 kHz at ±15 dB.

(2)

The

LEVEL

fader adjusts the output level. It can be used to achieve effective volume “boost”

or “cut.”

(3)

This

LED

illuminates when the EQ is activated. It also serves as a battery level indicator.

(4)

Use the footswitch to activate/deactivate the EQ.

(5)

Use this °" TS

IN

connector to plug in the instrument cable.

(6)

The °" TS

OUT

connector sends the signal to your amp.

Use the

DC IN

connection at the front of the unit to plug in a 9 V power supply (not included).

The

BATTERY COMPARTMENT

is located underneath the pedal cover. To install or replace the 9 V battery,

press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.

◊

The EQ700 has no on/off switch. As soon as you insert the jack into the in connector,

the EQ700 begins running. When not using the EQ700, remove the jack from the

in connector. This extends the life of the battery.

The

SERIAL NUMBER

is located at the bottom.

(2)

(6)

(1)

(3)

(5)

(4)