Behringer OD300 Manual

2-Mode Overdrive/Distortion Effects Pedal

Thank you for showing your confidence in us by purchasing the BEHRINGER OVERDRIVE DISTORTION OD300.

This effects pedal is ideally suited for electric guitars. Thanks to its high-performance features you can

create state-of-the-art overdrive, distortion or a combination of both effects.

1.

Controls

(1)

The

LEVEL

control adjusts the output level.

(2)

The

TONE

control allows you to shape your overall sound.

(3)

The

DRIVE

control adjusts the intensity of the overdrive/distortion effect.

(4)

Use the

MODE

control to adjust the balance between overdrive and distortion effect. In leftmost

position you got pure overdrive effect and in the rightmost position you get pure distortion.

(5)

The

ON/BATT

LED illuminates when the effect is activated. It also serves as a battery level indicator.

(6)

Use the footswitch to activate/deactivate the effect.

(7)

Use this ¼" TS

IN

connector to plug in the instrument cable.

(8)

The ¼" TS

OUT

connector sends the signal to your amp.

Use the

DC IN

connection at the front of the unit to plug in a 9 V power supply (not included).

The

BATTERY COMPARTMENT

is located underneath the pedal cover. To install or replace the 9 V battery,

press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.

◊

The OD300 has no on/off switch. As soon as you insert the jack into the in connector,

the OD300 begins running. When not using the OD300, remove the jack from the

in connector. This extends the life of the battery.

The

SERIAL NUMBER

is located at the bottom.

(5)

(1)

(8)

(6)

(3)

(2)

(4)

(7)