Behringer ULTRA METAL UM300 Manual

Heavy Metal Distortion Effects Pedal

Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA METAL UM300.

This high-quality effects pedal comes with a dual-gain circuitry that enables you to produce super thick,

tube-like distortion plus endless sustain. Thanks to its high-performance features you will achieve the

most extreme and sought-after hard rock or heavy metal distortion sounds.

1.

Controls

(1)

The

LOW

control allows yu to boost/cut the lo-frequency range.

◊

Please keep in mind that extrme distortion and EQ settings will increase nose and may

induce oscillation.

(2)

The two

MID FREQ

(uency) controls allow to boost/cut a defined mid-frequency range. The upper

control is used to increase or lower the mid range, the cntrol below adjusts the center frequency of

the mid range that is affected (200 Hz to 5 kHz).

(3)

The

LEVEL

control adjusts the output level.

(4)

The

ON/BATT

LED illumnates when the effect is activated. It also serves as a battery leve indicator.

(5)

Use the footswitch to activate/deactivate the effect.

(6)

Use this ¼" TS

IN

connector to plug in the instrument cable.

(7)

The ¼" TS

OUT

connector sends the signal to your amp.

Use the

DC IN

connectionto plug in a 9 V power supply (not included).

The

BATTERY COMPARTMENT

is located underneath the pedal cover. To install or replace the 9 V battery,

press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.

◊

The UM300 has no on/off switch. As soon as you insert the jack into the in connector,

the UM300 begins running. When not using the UM300, remove the jack from the

in connector. This extends the life of the battery.

The

SERIAL NUMBER

is located at the bottom.

(3)

(1)

(5)

(4)

(7)

(2)

(8)

(6)

(9)