Behringer XENYX X2222USB Manual - Page 11

11 XENYX X2442USB/X2222USB/X1832USB/X1622USB User Manual The following table shows which jacks on the console can be used for this purpose. X1622USB X1832USB X2222USB X2442USB optional: External effects device receives signal from... AUX SEND 2 AUX SEND 1 AUX SEND 2 AUX SEND 2 AUX SEND 1 External effects device routes signal back to... STEREO AUX RETURN 1 connectors STEREO AUX RETURN 2 connectors STEREO AUX RETURN connectors 1 or 2 STEREO AUX RETURN 1 connectors STEREO AUX RETURN 2 connectors Tab. 2.1: Connectors and controls for monitor mix with effect The effect signal reaches the monitor mix via... STEREO AUX RETURN 1 (TO AUX SEND 1) control MONITOR switch of the FX/AUX 2 RET STEREO AUX RETURN 1 (TO AUX SEND 1) control STEREO AUX RETURN 1 (TO AUX SEND 1) control STEREO AUX RETURN 2 (TO AUX SEND 2) control 2.3.6 Supplement to X1832USB The X1832USB has a stereo fader for the AUX RETURN FX and offers a variety of routing options: MUTE disables the effect return (but not PFL of course!), SOLO routes it to the Solo or PFL busses, SUB to the subgroups and MAIN to the main mix. STEREO AUX RETURN FX On consoles X1622USB and X1832USB this is the STEREO AUX RETURN 2, on consoles X2222USB and X2442USB this is the STEREO AUX RETURN 3. Use the STEREO AUX RETURN FX control to determine the level of the signal routed from the AUX RETURN FX jacks to the main mix. If nothing is connected to these jacks, the output of the built-in effects module will appear. MAIN MIX / TO SUBS This switch routes the signal fed in via the STEREO AUX RETURN FX jacks either to the main mix (not pressed) or to the submix (pressed). On the X2442USB you can select which subgroup the signal is assigned to (switches 1-2 / 3-4, to the right of MAIN MIX / TO SUBS). SOLO RETURNS Additionally, this model allows you to route the aux returns together to the solo bus and the PFL bus. The LED lights up when Solo is on. X1832USB Fig. 2.13: The FX/AUX 2 return fader of the X1832USB MON The MON switch routes the signals appearing at the AUX RETURN 2 jacks to the monitor path, along with the monitor signals from the channels. If you wish to route the effect signal to the monitor mix, you can also switch aux 1 to pre-fader, drive the effect device from the aux 1 output and return the effect signal via AUX RETURN 2 to the monitor signal. 2.3.7 XPQ Surround function (X1832USB only) STEREO AUX RETURN 4 (X2442USB only) This control behaves the same way as the other stereo aux returns. Additionally, it provides for a simple monitor path using the switch PHONES/CTRL ROOM ONLY. PHONES/CTRL ROOM ONLY Use this switch to route the signal appearing at the AUX RETURN 4 jacks to the control room and headphones outputs. X1832USB Fig. 2.14: Control elements of the surround function