Beltronics Vector 995 Owner's Manual - Page 9

31160_Vec995_OMrev 8/10/10 1:46 PM Page 17 Details of Programming Pilot (Power-on indication) Note: When you are using the Dark mode, the display will only show HD, AD, or CD, (Highway-Dark, AutoScan-Dark, or CityDark). Pilot HWY (Full description) In this setting, V995 will display "Highway," "City," or "AutoScan" as its power-on indication. (factory default) Pilot H (Letter) In this setting, V995 will display "H" for Highway, "C" for City, and "A" for AutoScan. Pilot V (Vehicle voltage) In this setting, V995 will continually display "H" for Highway, "C" for City, and "A" for AutoScan, and the vehicle's voltage. If the vehicle's voltage drops below 10.5 volts, a low voltage warning is displayed, followed by an audible alert. A high voltage warning is also given if the voltage goes above 16.0 volts. The high-voltage warning is also followed by an audible alert. Voice Voice On (Voice announcements on) In this setting, all radar, laser, and SWS messages (if programmed) will be announced using a digital voice. Voice Off (Voice announcements off) In this setting, only the distinct audio tone will be heard when a radar, Laser, or SWS message is detected. Power-on Sequence PwrOnSTD (Standard) In this setting, each time you turn on V995, it will display "BEL V995," "Laser," "Kaband," "K-band," "X-band," followed by a brief X-band alert. (factory default) If any bands have been changed from the factory default settings, a double X-band tone and corresponding message (i.e. "X OFF"), will alert you that one or more bands have been changed. PwrOnFST (Fast power-on) In this setting, V995 will provide a single X-band tone. If any bands have been changed from the factory default settings, a double X-band tone and corresponding message (i.e. "X OFF"), will alert you that one or more bands have been changed. 14 Signal Strength Meter MeterSTD (Standard meter) In this setting, the meter displays the band of the received signal, and a bar graph shows the relative signal strength. (factory default) MeterTEC (Tech Display meter) In this setting, the meter displays the actual numeric frequency of the radar signal received. Note: The Tech Display feature is explained in more detail on page 11. AutoMute aMute ON (AutoMute on) In this setting, V995's audio alerts will initially be at the volume you set, but after a few seconds, V995 will automatically reduce the volume level, to keep you informed, but not annoyed. (factory default) aMuteOFF (AutoMute off) With AutoMute off, V995's audio alerts will remain at the volume you set for the duration of the radar encounter. City Mode Sensitivity City STD (Standard) In this setting, when you put V995 in the City mode, X-band sensitivity is significantly reduced, to reduce annoyance from X-band intrusion alarms and motion sensors. (factory default) City LoX (Low X band sensitivity) In this setting, when you put V995 in the City mode, X-band sensitivity is reduced more than the standard setting. This will reduce X-band alarms from other sources even further, but also significantly reduces range to X-band traffic radar. City NoX (No X-band sensitivity) In this setting, when you put V995 in the City mode, V995 will not respond to any X-band signals. WARNING: Only choose this setting if you are absolutely certain that there are no X-band traffic radar units where you drive. NOTE: These settings only apply when V995 is operated in City mode. X-band sensitivity is not affected when used in "AutoScan" or "Highway" modes. 15