Bernina 810 Manual - Page 46

Straight border Satin Stitch embroidery Narrow border Preparation: Draw border line. underlay with paper. 1st run: Stitch width: 4 2nd run: Stitch length: almost 0 Sew satin stitch seam. Remove paper Corner: Sew to the corner. Lower drop and cut away surplus material. feed control. Sew three stitches using the hand wheel. Leaving the needle in 1st run: the work at the inside edge, raise foot, turn work. Make a loop with the cord, Foot: -Embroidery foot Foot: Small buttonhole foot Stitch width: 2-3 (according to material) Stitch length: almost 0 Needle position: centre lower foot and sew further three stit- Stitch width: 112/ ches. Raise drop feed control and con- Stitch length: 12/ Now completely cover the first satin tinue sewing carefully. Pull on the loop Needle position: centre stitch seam with a second. Lay the work until the foot no longer lies on the cor- under the foot in such a way that the ner. To make loop disappear pull the Draw pearl yarn No. 5 or 8 (according satin stitch seam is in the left groove of ends of the cord. (See diagram.) Push to material) through the hole of the em- the foot. Place the cord (mostly 1-ply) corner stitch over the corner and con- broidery foot. Sew seam with satin stitch. into the right hand groove of the foot. In tinue sewing. Cut surplus material away carefully. this way the yarn is joined exactly to the edge. Make the corner in the same way as with the wide border. 2nd run: Stitch width: 212/ -3 Stitch length: 1-1'/z Oversew edge with zigzag. At the same time guide through pearl cord (No.8 three- to five-ply) taking care that it nei- ; I ther slides over nor under the edge. 45