Bernina 810 Manual - Page 9
Winding, thread, bobbin, Inserting
View all Bernina 810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Winding of thread on bobbin Release handwheel: hold handwheel with the left hand. Release handwheel with the right hand by turning the knurled screw. Inserting the bobbin Place bobbin on winder spindle and press to the right. The winder Is then switched on. Insertion of bobbin into the bobbin case. When the bobbin is in the case make sure that the thread unwinds in the direction of the arrow. Draw thread from the reel clockwise round the pre-tensioning device (9) and from there - as shown In the picture - take to the mounted bobbin. Start motor with the foot starter. When the bobbin is full, the winding process stops automatically. Switch off motor, remove bobbin and push winder spindle back to left. Then re-tighten knurled screw on handwheel. t., "-a 0 V 4 Draw thread through slot and then under tension spring. Do not hold the bobbin. The bobbin must turn in the direction of the arrow when unwinding. 011111144) Insertion of the bobbin case into the hook. Raise needle to top position by turning the handwheel. As when remov- ing the bobbin case hold it by the `mj hinged latch with thumb and forefinger of the left hand. Hold bobbin case in such a way that the extension arm is directed upwards and fits into the niche of the hook race cover. Check-up: Pull end of thread. *P' 7