Bernina Bernette 340 deco User Guide - Page 17
Change Needle
View all Bernina Bernette 340 deco manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
16 Getting Ready to Embroider 1 3 1 2 Change Needle Turn off the power switch and disconnect the machine from the power supply. Raise the needle by turning the handwheel and lower the presser foot. Holding the needle tight, loosen the needle clamp screw by turning it counterclockwise. Remove the needle from the clamp. Insert a new needle into the needle clamp with the flat side of the needle to the rear. 1. Needle clamp screw 2. Flat side of the needle When inserting the needle into the needle clamp, push it up against the stopper pin and tighten the needle clamp screw firmly. 3. Stopper pin Note: Never use a blunt needle. To check needle straightness, place the flat side of the needle onto something flat (a needle plate, glass 4 etc.). A gap between the needle and the flat surface should be consistent. 4. Gap