Biostar K8M80-M7A K8M800-M7A user's manual - Page 20

B. CPU Overheated

Get Biostar K8M80-M7A PDF manuals and user guides View all Biostar K8M80-M7A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

K8M800-M7A B. CPU Overheated If the system shutdown automatically after power on system for seconds, that means the CPU protection function has been activated. When the CPU is over heated, the motherboard will shutdown automatically to avoid a damage of the CPU, and the system may not power on again. In this case, please double check: 1. The CPU cooler surface is placed evenly with the CPU surface. 2. CPU fan is rotated normally. 3. CPU fan speed is fulfilling with the CPU speed. After confirmed, please follow steps below to relief the CPU protection function. 1. Remove the power cord from power supply for seconds. 2. Wait for seconds. 3. Plug in the power cord and boot up the system. Or you can: 1. Clear the CMOS data. (See "Close CMOS Header: JCMOS1" section) 2. Wait for seconds. 3. Power on the system again. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
K8M800-M7A
18
B. CPU Overheated
If the system shutdown automatically after power on system for
seconds, that means the CPU protection function has been activated.
When the CPU is over heated, the motherboard will shutdown
automatically to avoid a damage of the CPU, and the system may not
power on again.
In this case, please double check:
1.
The CPU cooler surface is placed evenly with the CPU surface.
2.
CPU fan is rotated normally.
3.
CPU fan speed is fulfilling with the CPU speed.
After confirmed, please follow steps below to relief the CPU protection
function.
1.
Remove the power cord from power supply for seconds.
2. Wait for seconds.
3.
Plug in the power cord and boot up the system.
Or you can:
1.
Clear the CMOS data.
(See “Close CMOS Header: JCMOS1” section)
2. Wait for seconds.
3.
Power on the system again.