Biostar P4TGV P4TGV BIOS setup guide

Biostar P4TGV Manual

Get Biostar P4TGV PDF manuals and user guides View all Biostar P4TGV manuals
Add to My Manuals
Save this manual to your list of manuals

Biostar P4TGV manual content summary:

  • Biostar P4TGV | P4TGV BIOS setup guide - Page 1
    P4TGV BIOS Setup BIOS Setup 1 1 Main Menu 3 2 Standard CMOS Features 6 3 Advanced BIOS Features 9 4 Advanced Chipset Features 12 5 Integrated Peripherals 15 6 Power Management Setup 19 7 PnP/PCI Configurations 24 8 PC Health Status 26 9 Frequency Control 27 i
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 2
    P4TGV BIOS Setup BIOS Setup Introduction This manual discussed Award™ Setup program built into the ROM BIOS. The Setup program allows rest of this manual is intended to guide you through the process of configuring your system using Setup. Plug and Play Support These AWARD BIOS supports the Plug
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 3
    P4TGV BIOS Setup PCI Bus Support This AWARD BIOS also supports Version 2.1 of the Intel PCI (Peripheral Component Interconnect) local bus specification. DRAM Support DDR SDRAM (Double Data Rate Synchronous DRAM) are supported. Supported CPUs This AWARD BIOS supports the Intel Pentium ® 4 CPU. Using
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 4
    P4TGV BIOS Setup 1 Main Menu Once you enter Award BIOS™ CMOS Setup Utility, the Main Menu will appear on the screen. The Main Menu allows you BIOS defaults on manual (Figure 1,2,3,4,5,6,7,8,9) is just for reference, please refer to the BIOS installed on board, for update information. ! Figure 1. Main
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 5
    P4TGV BIOS Setup Advanced Chipset Features This submenu allows you to configure special chipset the voltage and clock may cause CPU or M/B damage!) Load Optimized Defaults This selection allows you to reload the BIOS when the system is having problems particularly with the boot sequence. These
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 6
    P4TGV BIOS Setup Set User Password If the Supervisor Password is not set, then the User Password will function in the same Abandon all changes made during the current session and exit setup. message will be displayed before proceeding. confirmation Upgrade BIOS This submenu allows you to upgrade
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 7
    P4TGV BIOS Setup 2 Standard CMOS Features The items in Standard CMOS Setup Menu are divided into 10 categories. Each category includes no, one or more than one
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 8
    P4TGV BIOS Setup Main Menu Selections This table shows the selections that you can make on the Main Menu. Item Options Description Date mm : dd : yy Set the installed in your system. 1.44M, 3.5 in 2.88M, 3.5 in None Video EGA/VGA CGA 40 Select the default video device. CGA 80 MONO 7
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 9
    P4TGV BIOS Setup Item Halt On Base Memory Extended Memory Total Memory Options All Errors No Errors All, but Keyboard All, but Diskette All, but Disk/ Key N/A N/A N/A Description Select the situation in which you want the BIOS to stop the POST process and notify you. Displays the amount of
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 10
    is enabled and an attempt is made to write to the boot sector, BIOS will display a warning message on the screen and sound an alarm beep. Disabled (default) Virus protection is disabled. Enabled Virus protection is activated. CPU Hyper-Threading This option allows you to enable or disabled
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 11
    P4TGV BIOS Setup Boot Up NumLock Status Selects the NumLock. State after power on Setup main menu. APIC Mode By selecting Enabled enables ACPI device mode reporting from the BIOS to the operating system. The Choices: Enabled (default), Disabled. MPS Version Control For OS The BIOS supports
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 12
    P4TGV BIOS Setup OS Select For DRAM > 64MB A choice other than Non-OS2 is only used selected in these items. The Choices: Floppy, LS120, HDD-0, SCSI, CDROM, HDD-1, HDD-2, HDD-3, ZIP100, LAN, HPT370, Disabled. Swap Floppy Drive For systems with two floppy drives, this option allows you to swap logical
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 13
    P4TGV BIOS Setup 4 Advanced Chipset Features This submenu allows you to configure the number of clock cycles of CAS latency depends on the DRAM timing. The Choices: By SPD (default), Manual. CAS Latency Time When synchronous DRAM is installed, the number of clock cycles of CAS latency depends on
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 14
    P4TGV BIOS Setup DRAM RAS# to CAS# Delay This field let you insert a area, a system error may result. The Choices: Enabled (default), Disabled. Video BIOS Cacheable Select Enabled allows caching of the video BIOS, resulting a better system performance. However, if any program writes to this memory
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 15
    P4TGV BIOS Setup Memory Hole At 15M-16M You can reserve this area of Delayed Transaction The chipset has an embedded 32-bit posted write buffer to support delay transactions cycles. Select Enabled to support compliance with PCI specification. The Choices: Enabled (default), Disabled. AGP Aperture
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 16
    P4TGV BIOS Setup 5 Integrated Peripherals ! Figure 5. Integrated Peripherals Onboard PCI LAN This item allows you to enable or disable Onboard PCI LAN. The Choices: Enabled (default), Disabled. Onboard LAN Boot ROM This item allows you to enable or disable Onboard LAN Boot ROM. The Choices: Disabled
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 17
    P4TGV BIOS Setup USB Keyboard Support The default value is Disabled. Enabled Disabled (default) Enable USB Keyboard Support. Disable USB Keyboard Support. AC97 Audio/ Modem This item allows you to Disable the AC97 audio controller integrated in ICH4 or to set Auto to let the Bios detect the AC97
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 18
    P4TGV BIOS Setup The Choices: 2F8/IRQ3, Disabled (default), Auto, 3F8/IRQ4 , 3E8/IRQ4, 2E8/IRQ3. UART Mode Select This item allows you to determine which Infrared (
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 19
    P4TGV BIOS Setup IDE Devices Control Press Enter to configure the onboard IDE environment requires a DMA driver (Windows 95 OSR2 or a third party IDE bus master driver). If your hard drive and your system software both support Ultra DMA/100, select Auto to enable BIOS support. The Choices: Auto
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 20
    P4TGV BIOS Setup 6 Power Management Setup The Power Management Setup Menu Suspend to RAM S1 & S3 POS+STR Run VGABIOS if S3 Resume Choosing Enabled will make BIOS run VGA BIOS to initialize the VGA card when system wakes up from S3 state . The system time is shortened if you disable the function
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 21
    P4TGV BIOS Setup does not support the initialization feature , the display may work abnormally or not = 1 hr. HDD Power Down = 15 min Max. Power Saving Maximum power management only available for sl CPU's. Suspend Mode = 1 min. HDD Power Down = 1 min. User Defined (default) Allows you to set
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 22
    P4TGV BIOS Mode When enabled and after the set time of system inactivity, all devices except the CPU will be shut off. The Choices: Disabled (default), 1Min, 2Min, 4Min, 8Min, following options: Wake-Up by PCI card When you select Enable, a PME signal from PCI card returns the system to Full On state
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 23
    P4TGV BIOS Setup Wake Up On LAN To use this function, you need a LAN add-on card which support power on function. It should also support the wake-up on LAN 98. manual intervention. There are 3 sources that provide current to the CMOS area that retains these Power-On instructions; the motherboard
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 24
    P4TGV BIOS Setup There are 3 options: "Former-Sts", "On", "Off". "Off" (default) lost. Means always set CMOS to the "Off" status when AC power is "On" Means always set CMOS to the "On" status when AC power is lost "Former-Sts" Means to maintain the last status of the CMOS when AC power is
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 25
    to it. The system needs to record and update ESCD to the memory locations. These locations (4K) are reserved in the system BIOS. If the Disabled (default) option is chosen, the system's ESCD will update only when the new configuration varies from the last one. If the Enabled option is chosen, the
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 26
    BIOS will detect the system resources and automatically assign the relative IRQ and DMA channel for each peripheral.By Choosing "Manual", the user will need to assign IRQ & DMA for add-on cards access to be forwarded to the ISA bus. The non-VGA ISA graphic controller can then snoop the data on the
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 27
    P4TGV BIOS Setup 8 PC Health Status ! Figure 8. PC Health Status Shutdown Temperature This item allows you to set up the CPU shutdown Temperature. This item only effective under Windows 98 ACPI mode. The Choices: Disabled (default), 60OC/140OF, 65OC/149OF, 70OC/158OF, 75OC/167OF. CPU Vcore/AGP
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 28
    P4TGV BIOS Setup 9 Frequency Control ! Figure 9. Frequency Control CPU Clock Ratio This item allows you to select the CPU Ratio. CPU Voltage This item allows you to select CPU Voltage Regulator. The Choices: Default (default), +1.7％, +3.45％, +5.1％. DDR Voltage This item allows you to select DDR
  • Biostar P4TGV | P4TGV BIOS setup guide - Page 29
    P4TGV BIOS Setup CPU Clock This item allows you to select CPU Clock, and CPU over clocking. If unfortunately, the system's frequency that you are selected is not functioning, there are two methods of booting-up the system. Method 1: Clear
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
P4TGV BIOS Setup
i
BIOS Setup
.......................................................................................
1
1 Main Menu
...................................................................................................
3
2 Standard CMOS Features
.............................................................................
6
3 Advanced BIOS Features
.............................................................................
9
4 Advanced Chipset Features
........................................................................
12
5 Integrated Peripherals
.................................................................................
15
6 Power Management Setup
..........................................................................
19
7 PnP/PCI Configurations
..............................................................................
24
8 PC Health Status
.........................................................................................
26
9 Frequency Control
......................................................................................
27