Bissell PowerForce Vacuum User Guide - English - Page 9

Maintenance and care Check rotating floor brush and drive belt (continued) 5. Clean strings, hair and other debris from rotating floor brush, paying particular attention to brush ends. Motor Pulley 6. Clean strings, hair and other debris from motor pulley and drive belt areas. 7. Check drive belt carefully for wear, cuts or stressed areas. Replace if worn. 8. Check air passageway for obstructions. Remove debris from this area. Air Passageway Replace drive belt Use only BISSELL Style 7 Replacement Belts (#32074) in your BISSELL PowerForce. 1. Unplug cleaner from electrical outlet. 2. With rotating floor brush removed from vacuum cleaner (Steps 1-4 of Check rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley. Discard old drive belt. 3. Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles. 4. Place ends of rotating floor brush down into slots on sides as shown. 5. Turn rotating floor brush by hand several times in direction of motor pulley. If properly installed, drive belt will center itself. 6. Reposition brush cover and four screws. Tighten screws securely. Make sure end of brush cover is snapped into place. Press here Brush Cover Replace light bulb (select models) Select models are equipped with a headlight. Use only BISSELL Replacement Bulbs in your BISSELL PowerForce. 1. Unplug cleaner from electrical outlet. 2. Insert a flat screwdriver or coin into the slot on the right of the lens and gently push inner latch to the left as shown to remove the lens. 3. Remove the bulb from the socket by grasping bulb and pulling straight out. Install the new bulb by pushing it gently into the socket until the bulb snaps into place 4. Reposition lens, by inserting tab on left side and then pushing the right side back into place. www.bissell.com 800.237.7691 196