Bosch 1619EVS Operating Instructions - Page 14

BM2610995777 10/03 10/7/03 4:51 PM Page 14 DUST COLLECTION WHILE EDGE FORMING The RA1170 dust extraction hood (optional accessory) is used for dust collection when edge-forming (Fig. 15). ! WARNING Read and understand these instructions and tool manual for use of these accessories. Do not reach in area of the bit while the router is ON or plugged in. ! CAUTION To avoid entangling hoses, do not use this dust extraction hood at the same time as any other dust extraction hood. ATTACHING DUST EXTRACTION HOOD You can attach the hood in several places according to your needs or preferences. This hood is attached using two of the screw holes on the router base that are used to attach the router's sub-base. Choose the desired location for the hood. Loosen and take out the two screws from the router base and attach the dust extraction hood - over the router's sub-base - using the screws provided with the hood. Securely tighten the screws (Fig. 16). FIG. 15 ROUTER SUB-BASE WORKPIECE EDGE DUST EXTRACTION HOOD The dust extraction hood itself is sized to accept 35mm vacuum hoses. Also included is the VAC002 adapter that will connect the hood to 1-1/4'' and 1-1/2'' vacuum hoses. FIG. 16 M4 x 16mm SCREW SUB-BASE DUST EXTRACTION HOOD M4 x 16mm SCREW -14-