Bosch SGV45E03UC Quick Reference Instructions

Bosch SGV45E03UC Manual

Bosch SGV45E03UC manual content summary:

  • Bosch SGV45E03UC | Quick Reference Instructions - Page 1
    the dishwasher door open, locate the label on the middle of the door. There you will find the: • Model Number • Serial Number (FD#########) 1) Open the door Hidden Top Controls 2) Turn on 4) Close the door to start 3) Select a cycle ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS
  • Bosch SGV45E03UC | Quick Reference Instructions - Page 2
    de cycle. Les durées de cycle données dans le guide d'utilisation et d'entretien sont en fonction de charges sales normales et circuit 4) L'appareil se met en marche 3) Choisir un cycle Pour communiquer avec le service à la clientèle La porte du lave-vaisselle ouverte, repérer l'étiquette sur
  • 1
  • 2

2
1
3 TBS MAX
2 TBS (25 ML)
1 TBS (15 ML)
Use fresh powdered detergent
for best results
1 tablespoon will clean most loads
3 tablespoons Max, do not overfill
When using detergent tabs, lay
them flat to avoid contact with the
cover
GETTING STARTED
WITH YOUR NEW DISHWASHER
STEP 1- ADDING RINSE AGENT
To add Rinse Agent
pour on the arrow
Turn arrow to
adjust the amount
of rinse agent
dispensed
Add Rinse Agent when the light
on the control panel illuminates
or (Model Dependent)
Rinse Agent Level indicator on
the dispenser changes to a
light silver color
Add
Detergent
To close
If you should
need to open
the cover
STEP 2 - ADDING DETERGENT
STEP 3 - TO START THE DISHWASHER
Exposed
Front
Controls
Hidden
T
op
Controls
ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND
IMPORTANT SAFETY NOTICES.
Cancel Drain
To Contact Customer Service
With the dishwasher door open, locate the label on the
middle
of the door. There you will find the:
Model Number
Serial Number (FD#########)
Run Time
To save energy, this dishwasher has a "Smart Control" that
automatically adjusts the cycle based on soil loads and incom-
ing water temperature. The "Smart Control" makes decisions
that can cause the cycle time and water usage to adjust at
discrete times, and suddenly change in midcycle. The cycle
times listed in the Use and Care manual are based on normal soil
loads and 120°F incoming water and will vary based on your
actual conditions.
When is the Cycle Complete
Depending on model you can tell when your unit has completed
the cycle in one of the following ways. Please refer to your Use
and Care manual for complete details
Countdown Display at "0"
Clean Light illuminates
Cycle completion signal sounds (tone adjustable)
Cycle indicator light that shines on floor goes out
Canceling a Cycle
To cancel a cycle in process, press and hold the two buttons
labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher
as normal
FREQUENTLY ASKED
QUESTIONS
For Proper Drying Always use Rinse Agent
even if your detergent containes Rinse Agent
Arrow
Turn
Decrease
for
Streaks on
glasses
Increase
for
Spots on
glasses
1
2
Push the blue button in
(NOT DOWN)
Lift tab to
open
Slide cover fully left
Push rear of cover down
firmly until you hear the
CLICK
1) Close the door
2) Turn on
2) Turn on
3) Select a cycle
3) Select a cycle
1) Open the door
4) The unit will
then start
4) Close the
door to start
Rinse Agent
Level
9000162018 (8602)