Bosch SHE7ER55UC Installation Instructions - Page 10

Installation of Rubber Drain Hose Adaptor For a large port, use the drain hose as it is. 1. For a small port, insert the rubber drain hose adaptor into the drain hose end. 2. Obtain the Rubber Drain Hose Adaptor (J) spring clamp from the Dishwasher Installation Kit (do not substitute). 3. Insert the dishwasher drain hose into the end of the drain hose (see Figure 15). Be sure to fully insert the drain hose. 4. Use the clamp provided to attach the Rubber Drain Hose Adaptor to the house plumbing as shown in Figure 16. Figure 15 J Top Mount is used for countertops made of wood or other materials that can be easily drilled. Orient the mounting brackets as shown in Figure 17, and position the two small tabs on the mounting brackets over the two slots on the dishwasher's front corners. Push the mounting brackets down firmly to insert the tabs into the slots. C Top Mount Figure 17 Figure 16 G Side Mount is used for countertops made of marble, granite, or other very hard materials that cannot be easily drilled. Bend the mounting brackets along the small holes and in the same direction as the two small tabs. Orient the mounting brackets as shown in Figure 18, and position the two small tabs on the mounting brackets over the two slots on the dishwasher's front corners. Push the mounting brackets down firmly to insert the tabs into the slots. Side Mount Figure 18 C Installation of Mounting Brackets Alternate Side Mount for opening 235/8″ (600mm). Insert a side mount force distributor (M) in each side as shown in Figure 19. Before installing the supplied countertop mounting brackets, decide which method of securing the dishwasher into its enclosure will be used. Once the mounting brackets are installed on the dishwasher, removing them is difficult and will damage the mounting brackets and the dishwasher. The dishwasher can be secured into its enclosure in 3 ways: NOTE: If your dishwasher opening width measures >235/8″ (600mm) use the TOP or SIDE MOUNT mounting methods. If your dishwasher opening width measures 235/8″ (600mm) use the ALTERNATE SIDE MOUNT mounting method. 10 M M M Figure 19 Alternate Side Mount 10