Bosch WZ18NV312-0 User Manual

MAN-WZ20-04

Important

Please read this document carefully before installation and initial use.

Keep for future reference.

•

An unregulated power supply can cause damage to the camera.

•

Do not attempt to disassemble the camera to gain access to the internal components.

Refer servicing to Bosch Security

Systems. Inc.

•

It is recommended that the camera be used with a monitor that has a CCTV quality 75

Ω

video impedance level.

If your

monitor is switched to a high impedance level, then please adjust accordingly.

•

Never direct the camera towards the sun or any bright or reflective light.

Doing so may cause smearing on the picture and

possible damage to the CCD

Important Safety Instructions

1.

Read these instructions.

2.

Keep this instruction.

3.

Heed all warnings.

4.

Follow all instructions.

5.

Do not use this apparatus near water.

6.

Clean only with dry cloth.

7.

Do not block any ventilation openings.

Install in accordance with manufacturer instructions.

8.

Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that

produce heat.

9.

Do not defeat the safety purpose of the polarized or grounding-type plug.

A polarized plug has two blades with one wider

than the other.

A grounding type plug has two blades and a third grounding prong.

The wide blade or the third prong is

provided for your safety.

If the provided plug does not fit into your outlet, consult an electrician for replacement of the

obsolete outlet.

10.

Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the power

where they exit from the apparatus.

11.

Only use attachments/accessories specified by the manufacturer.

12.

Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.

When a

cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.

Unplug this apparatus during lightning storms or when unused for long periods of time.

14.

Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been damaged in a way,

such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the

apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

FCC Note

NOTE: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. As part of its’ normal

operation this device can generate radio frequency energy and if not installed and used in accordance with the installation manual may

cause interference to radio communications. However, there is no guarantee that interference will not occur on a particular installation. If

the device does cause interference to radio or television reception the user is encouraged to try to correct the interference by one or more

of the following measures:

1) Fit Ferrite beads on all cable to and from the power

supply box, within the box walls.

2) Route the composite cable between the camera and the power supply in steel conduit piping over the entire run of the cable up to and

including connection to a deep conduit base fitted under the camera and a conduit fitting adaptor in the wall of the PSU box.

3) Contact BOSCH Service Center for further advice. .

Installation Guide

WZ18NV312-0 (NTSC)

|

WZ18PV312-0 (PAL)