Brother International Innov-is VQ3000 Instruction manual for using the sensor
Brother International Innov-is VQ3000 Manual
View all Brother International Innov-is VQ3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Brother International Innov-is VQ3000 manual content summary:
- Brother International Innov-is VQ3000 | Instruction manual for using the sensor - Page 1
to specify the sewing end point using the sensor pen differ from those described in the Operation Manual. Refer to the following. We recommend that you keep this manual with the Operation Manual. Note • In order to specify the location accurately, use the sensor pen to touch the end point - Brother International Innov-is VQ3000 | Instruction manual for using the sensor - Page 2
f With the sensor pen, touch the location be specified as the sewing end point. to → The distance from the current needle position to the touched location appears. a f b e d c a It shows how many times you need to touch the sewing end point, once or twice. Touch once Touch twice b Press - Brother International Innov-is VQ3000 | Instruction manual for using the sensor - Page 3
Stitch End Mode Key The end of stitching is not adjusted. When the end point is reached, sewing stops immediately, even if the stitch pattern is not complete. The length of the stitch pattern is adjusted so that sewing will stop at the specified end point with a complete pattern. h With the sensor - Brother International Innov-is VQ3000 | Instruction manual for using the sensor - Page 4
■ Reusing the Previous Setting When using the same fabric and pattern to sew the same length, the previous setting can be used again, instead of using the sensor pen to specify the sewing end point each time. To use the previous setting, repeat steps c through e then press sensor pen. in step f,
1
Before start sewing, test the pattern first from steps
a
to
e
to see if the stitch can be used with this
function. Before starting to sew, mark the end
point.
a
Turn on the machine.
b
Press the Utility or Character Decorative
Stitch tab on the Utility Stitch Screen.
c
Start sewing, and then stop the machine
when the desired sewing end point enters
the sensor pen touch range.
d
Press
.
→
The sensor functions screen appears.
e
Press
.
→
The sewing end point setting screen appears.
Using the Sensor Pen to Specify the Sewing End Point
(Version 1.05 or later)
The procedures to specify the sewing end point using the sensor pen differ from
those described in the Operation Manual. Refer to the following.
We recommend that you keep this manual with the Operation Manual.
Note
• In order to specify the location accurately, use the sensor pen to touch the end point twice. Be sure to
touch the same point.
• Before starting to sew, mark the end point.
Note
• If the needle drop point is being specified
with the sensor pen within 70 mm (approx.
2-3/4 inches) from the sewing end point, the
machine will not require the second touch.
After completing step
f
, continue with
step
j
. However, the actual sewing end
point may be slightly different than the
specified location.
In order to specify the location accurately,
stop the machine at a location more than
70 mm (approx. 2-3/4 inches) away from
the sewing end point before specifying it for
the first time.
Memo
• If the needle drop point is greater than
100 mm (approx. 4 inches) from the
selected ending point using the sensor pen,
a more accurate position can be specified
the second time that the point is touched.
Note
• If
is not available, the sewing end
point cannot be specified with the selected
stitch pattern. Select a different stitch
pattern.