Brother International JX3135F Quick Reference Guide
Brother International JX3135F Manual
View all Brother International JX3135F manuals
Add to My Manuals
Save this manual to your list of manuals |
Brother International JX3135F manual content summary:
- Brother International JX3135F | Quick Reference Guide - Page 1
completamente Be sure to use the correct bobbin. Asegúrese de que utiliza la bobina correcta. Actual 11.5mm Size 7/16" Tamaño real Please read "IMPORTANT SAFETY INSTRUCTIONS" and the detailed instructions in the Operation Manual. Lea "INSTRUCCIONES DE SEGURIDAD IMPORTANTES" y las instrucciones - Brother International JX3135F | Quick Reference Guide - Page 2
SAFETY INSTRUCTIONS" and the detailed instructions in the Operation Manual. Lea "INSTRUCCIONES DE SEGURIDAD IMPORTANTES" y las instrucciones detalladas que aparecen en el Manual de instrucciones. • Guide the el hilo • 5 cm (2 inches) • 5 cm (2 pulg.) You can start sewing. • Puede comenzar a coser.
1
11.5mm
7/16"
Actual
Size
Tamaño
real
Lower Threading
Enhebrado del hilo inferior
Quick Reference Guide
Guía de referencia rápida
Be sure to use the
correct bobbin.
Asegúrese de que
utiliza la bobina
correcta.
Please read “IMPORTANT
SAFETY INSTRUCTIONS” and
the detailed instructions in the
Operation Manual.
Lea “INSTRUCCIONES DE
SEGURIDAD IMPORTANTES” y
las instrucciones detalladas que
aparecen en el Manual de
instrucciones.
See other side for “2. Upper Threading”.
Consulte en la otra cara “2. Enhebrado del hilo superior”.
Pull up the spool
pin completely
•
Tire del portacarrete
completamente
•
XF5978-101
①
Align the notch to
the projection
•
Alinee la muesca
con el saliente
•
Slide the bobbin
winder shaft to the
right
•
Deslice el eje de la
devanadora hacia la
derecha
•
Click!
When the bobbin is
full, the bobbin will
spin slowly
•
Cuando esté llena, la
bobina girará
lentamente
•
Leave 1 cm (1/2 inch)
of thread from the
hole on the bobbin
•
Deje 1 cm (1/2 pulg.)
de hilo desde el orificio
de la bobina
•
Wind the thread few
times around the
bobbin
•
Enrolle el hilo unas
cuantas veces
alrededor de la bobina
•
7 – 10 cm
(3-4 inches)
•
7 – 10 cm
(3-4 pulg.)
•
Hold the end of
the thread
•
Sujete el
extremo del hilo
•
Pull the thread
completely
•
Tire del hilo
completamente
•
Cut the thread
with the cutter
•
Corte el hilo con
el cortador
•
Put the projection into the groove
•
Coloque la proyección en la ranura
•
Push the
bobbin down
•
Empuje la
bobina abajo
•