Brother International HL-2270DW Network Users Manual - English - Page 32

Control panel setup Enabling or disabling the wireless network (For HL-2270DW) 5 If you want to switch the wireless network to enabled/disabled (disabled is the default), please follow these steps: a Make sure that the power cord is plugged in. b Turn on the machine and wait until the machine is in the Ready state. c Hold down Go for 10 seconds. Release Go when the machine prints a Network Configuration page that indicates the current network settings. Note 5 If you release Go in less than 10 seconds, the machine will print if you have any reprint data. d Check the text to the right of IEEE 802.11b/g in the Node Type section. Active means that the wireless setting is enabled and Inactive means that the wireless setting is disabled. Brother NC-XXXXw, IEEE 802.11b/g (Active) Firmware Ver.0.20 (07.11.22) XX-XX-XX-XX-XX-XX BRWXXXXXXXXXXXX BRNXXXXXXXXXXXX BINARY_P1 TEXT_P1 POSTSCRIPT_P1 PCL_P1 BRNXXXXXXXXXXXX_AT Note You can switch the wireless network to enabled/disabled, using the BRAdmin applications or Web Based Management (web browser). (For more information, see Other Management Utilities on page 6.) 28