Brother International HL-4570CDW Users Manual - English - Page 189

Appendix Bar code, expanded character, line block drawing and box drawing offset in X-axis A n = 'xnnn' or 'Xnnn' This parameter shows the offset from the left margin in the 'u'- or 'U'-specified unit. Bar code & expanded character offset in Y-axis A n = 'ynnn' or 'Ynnn' This parameter shows the downward offset from the current print position in the 'u'- or 'U'-specified unit. Bar code, expanded character, line block drawing and box drawing height A n = 'hnnn', 'Hnnn', 'dnnn', or 'Dnnn' 1 EAN13, EAN8, UPC-A, ISBN (EAN13, EAN8, UPC-A), ISBN (UPC-E): 22 mm 2 UPC-E: 18 mm 3 Others: 12 mm Expanded characters i 2.2 mm (preset) A Line block drawing and box drawing i 1 dot This parameter shows the height of bar codes or expanded characters as shown above. It can start with 'h', 'H', 'd', or 'D'. The height of bar codes is shown in the 'u'- or 'U'-specified unit. The default setting of the bar code height (12 mm, 18 mm or 22 mm) is determined by the bar code mode selected by 't' or 'T'. Expanded character width, line block drawing and box drawing A n = 'wnnn' or 'Wnnn' Expanded character i 1.2 mm Line block drawing and box drawing i 1 dot This parameter shows the width of expanded characters as shown above. Expanded character rotation A n = 'a0' or 'A0' n = 'a1' or 'A1' n = 'a2' or 'A2' n = 'a3' or 'A3' 'Upright (preset) 'Rotated 90 degrees 'Upside down, rotated 180 degrees 'Rotated 270 degrees Bar code data start A n = 'b' or 'B' Data that follows 'b' or 'B' is read in as bar code data. Bar code data must end with the ' \ ' code (5CH), which also ends this command. The acceptable bar code data is determined by the bar code mode selected by 't' or 'T'. 183