Brother International LS-2125i Users Manual - English - Page 39

Stop sewing when the needle is at the left side f of the stitching, and then raise the needle by turning the handwheel toward you. Select stitch "b" of the 4-step automatic g buttonhole (1). Start sewing, and then sew the length of the h chalk line. Insert a pin at the end of the buttonhole p stitching to prevent the stitching from being cut, and then use a seam ripper to cut towards the pin and open the buttonhole. 2 Stop sewing when the needle is at the right i side of the stitching, and then raise the needle 1 by turning the handwheel toward you. a Seam ripper Select stitch "c" (same as "a") of the 4-step b Pin j automatic buttonhole (1). CAUTION 3 Start sewing. Sew 5 to 6 stitches. k ● When opening the buttonhole with the seam ripper, do not place your hands in the cutting Stop sewing when the needle is at the right l side of the stitching, and then raise the needle by turning the handwheel toward you. path, otherwise injuries may result if the seam ripper slips. Do not use the seam ripper in any other way than how it is intended. Select stitch "d" of the 4-step automatic m buttonhole (1). Start sewing. Sew the right side of the n buttonhole until the needle reaches the stitching sewn in step e. For reinforcement, turn the fabric 90 degrees counterclockwise, select the straight stitch (6 through 10) with the desired length, and then sew to the edge of the front bar tack. Raise the presser foot lever, remove the o fabric, and cut the thread. 37