Brother International MFC 495CW Quick Setup Guide - English - Page 33

For Wireless Network Users 19 Configure the wireless settings using the automatic wireless (onepush) method a Confirm your wireless access point/router has the SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ symbol as shown below. b Place the Brother machine within range of your SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ access point/router. The range may differ depending on your environment. Refer to the instructions provided with your access point/router. c Push the SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ button on your wireless access point/router. See the user's guide for your wireless access point/router for instructions. d On your machine, press Menu. Press a or b to choose Network and press OK. Press a or b to choose WLAN and press OK. Press a or b to choose SES/WPS/AOSS and press OK. When Network I/F switched to Wireless is displayed, press OK to accept. This will start the wireless setup wizard. This feature will automatically detect which mode (SecureEasySetup™, Wi-Fi Protected Setup or AOSS™) your access point/router uses to configure your machine. Note If your wireless access point/router supports Wi-Fi Protected Setup (PIN Method) and you want to configure your machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi Protected Setup in the Network User's Guide on the CD-ROM. e If the LCD shows Connected, the machine has successfully connected to your wireless access point/router. You can now use your machine in a wireless network. If the LCD shows Setting WLAN, then Connection Error, a session overlap was detected. The machine has detected 2 or more wireless access points/routers on your network that have the SecureEasySetup™, Wi-Fi Protected Setup mode or AOSS™ mode enabled. Make sure that only one wireless access point/router has one of these modes enabled and try starting from c again. If the LCD shows Setting WLAN, then No Access Point, the machine has not detected the access point/router on your network with the SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ mode enabled. Move your machine close to the access point/router and try starting from c again. If the LCD shows Setting WLAN, then Connection Fail, the machine has not successfully connected to your wireless access point/router. Try starting from c again. If the same message is indicated again, reset the machine back to the default factory settings and try again. For resetting, see Restore the network settings to factory default on page 45. LCD messages when using the SES/WPS/AOSS control panel menu Setting WLAN Connecting SES/WPS/AOSS Connected Connection Error No Access Point Connection Fail Searching for or accessing the access point, and downloading settings from the access point. Connecting to the access point. The machine has successfully connected. A session overlap was detected. The access point detection failed. Connection failed. The machine was not able to connect with the access point. Try the configuration from c on page 33 again. Note You can also manually configure the wireless settings following the steps starting at step 18-a on page 30. f Press OK. 33 Wireless Network