Brother International MFC-J410w Basic Users Manual - English - Page 48
Connections, If You Do Not Subscribe to Distinctive, Ring Service
View all Brother International MFC-J410w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Chapter 6 • If You Do Not Subscribe to Distinctive Ring Service: You must plug your TAD into the EXT. jack of your machine. If your TAD is plugged into a wall jack, both your machine and the TAD will try to control the telephone line. (See the illustration below.) • Before you connect the external TAD, remove the protective cap (2) from the EXT. jack on the machine. 1 1 Connections 6 The external TAD must be plugged into the jack labeled EXT. Your machine cannot work properly if you plug the TAD into a wall jack (unless you are using Distinctive Ring). a Plug the telephone line cord from the telephone wall jack into the jack labeled LINE. b Remove the protective cap (1) from the jack labeled EXT, and then plug the telephone line cord from the external TAD into the EXT. jack. (Make sure this cord is connected to the TAD at the TAD's telephone line jack, and not its handset jack.) 2 1 TAD 2 Protective Cap When the TAD answers a call, the LCD shows Telephone. IMPORTANT DO NOT connect a TAD elsewhere on the same telephone line. 1 c Set your external TAD to four rings or less. (The machine's Ring Delay setting does not apply.) d Record the outgoing message on your external TAD. e Set the TAD to answer calls. f Set the Receive Mode to External TAD. (See Choose the correct Receive Mode on page 25.) 34