Canon FAX-JX200 FAX-JX200/JX201 User'sGuide - Page 21

Sending Faxes Sending Documents Before you send a document, see "Documents Requirements" on page 15, and "Loading Documents and Paper" on page 16. Note z If paper jams, see "Troubleshooting" on page 53. z You can send up to 20 A4-size (10 legal-size) pages at a time (based on the Canon FAX Standard Chart No.1, standard resolution). You cannot add pages while the fax is sending. z The fax stores the document temporally in memory when sending a document, however, when memory is full, it will send the document as it scans the document without storing document in memory. „ Direct Sending 1 Load the document face up into the Document Tray. See "Loading Documents and Paper" on page 16. You can set the scanning resolution and contrast (see page 20). 2 Dial the receiving party's fax number. Use one of the dialing methods described in this chapter. TEL= 3456xxxx 3 Press [Start/Copy]. The fax begins sending. Note z If an error occurs during sending, the fax beeps intermittently for a few seconds and an error message appears on the LCD. If this happens, correct the problem and then press [Stop], then try sending the document again. See "LCD Messages" on page 62. z The fax automatically redials if the receiving party does not answer or if the line is busy. (You can specify the number of times it redials; see on page 39.) „ Manual Sending If you would like to first speak with the person you are sending the document to, use manual sending. 1 Load the document face up into the Document Tray. See "Loading Documents" on page 16. You can set the scanning resolution and contrast (see page 20). 2 Pick up the Handset or press [Hook] and dial the receiving party's fax number. Use one of the dialing methods described in this chapter. TEL= 3456xxxx Sending Faxes 19