Canon FAX-JX200 FAX-JX200/JX201 User'sGuide - Page 66

„ INK ABS NEAR FUL Cause The ink absorber is almost full. „ NO INK Action Printing will no longer be possible once the ink absorber is full. Contact the service center immediately. Press [Stop] to continue printing. Cause Ink has run out. „ INK VOL UNKNOWN Action Replace the FINE Cartridge (see page 43). Cause The remaining level of the ink cannot be correctly detected. „ MEMORY FULL Action A FINE Cartridge that was once empty is installed. Replace the FINE Cartridge (see page 43). Cause Action The fax's memory is full because it has received too many documents, or a very long or detailed document. The fax's memory is full because you either tried to send or copy too many pages at once, or you tried to send or copy a very long or detailed document, using memory sending. Print and delete any documents stored in memory (see page 34). Then start again. Free up space in the fax's memory by printing or deleting any documents in memory you no longer need (see page 34). If multiple pages are loaded, separate the pages into smaller stacks. If not, try sending the document by direct sending (see page 19). „ NO TEL # Cause The one-touch speed dialing button or coded speed dialing code you entered has not been registered. Action Register the one-touch speed dialing button or coded speed dialing code (see page 13). „ REC'D IN MEMORY Cause Action The fax received the document in memory because paper or ink ran out, a paper jam occurred, or the incorrect FINE Cartridge was installed. The fax receives documents in memory because the feature is selected. Load paper in the Multi-Purpose Tray (see the Easy Setup Instructions), replace the FINE Cartridge (see page 43) or clear the paper jam (see page 53). Print any documents stored in memory (see page 34). Press [ON/OFF] to cancel (see page 32). Received faxes will be printed automatically when this feature is disabled. „ RECOMEND NEW CRT Ink is low. Cause Action Replace the FINE Cartridge (see page 43). „ REMOVE DOCUMENT Cause The document is set while printing. Action Remove the document. Press [Stop] and try printing again. 64 Troubleshooting