Canon LASER CLASS 650i Wireless LAN Guide

Canon LASER CLASS 650i Manual

Canon LASER CLASS 650i manual content summary:

  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 1
    P.1-1 Troubleshooting ʁ P.2-1 Starter Guide For procedures other than printer installation and wireless LAN setup, please refer to the [Starter Guide]. Read this guide before setting up the wireless LAN This guide describes the wireless LAN setup procedure and problems encountered
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 2
    guides with step-by-step instructions to assist you through the process from Canon's home page. You can access Canon's Canon's home page by following the procedures shown below. 1. Insert the User Software CD-ROM accompanied with the machine into the CD slot of your computer. 3. Click [Canon
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 3
    be completed. If they are not set up, you will not be able to use the machine on the wireless LAN network even if you perform the following steps. For more information, see the instruction manual for the network device you are using, or contact the networking device manufacturer. Internet Required
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 4
    to enable Wired/Wireless LAN selection. Changes effective after main power is turned OFF and ON. It is necessary to turn OFF/ON the machine for the settings to take effect. 3. Press [ ] or [ ] to select, and press [OK]. Network Settings Select Wired/Wireles Wireless LAN Settin... TCP/IP Settings
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 5
    or connecting manually. No Is there a WPS button? • For checking whether it supports the WPS, find the descriptions such as "... supports WPS..." or "Step4-A Setting the Machine Using the WPS (Push Button Mode)," on p.1-4. Proceed to "Step4-B Setting the Access Point Manually and Connecting," on
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 6
    approximately 5 seconds. You do not need to turn the machine OFF and ON at this stage. Changes effective after main 5. Press [OK]. See Wireless LAN Setting Guide to perform settings. OK 8. Within 2 you are using. Please refer to the instruction manual for your wireless LAN routers and/or access
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 7
    Connected. 10. Wait until the machine retrieves the IP address automatically (approx. 2 minutes). If you want to set the IP address manually, see the following. e-Manual "Network Settings" - "Basic Network completed. Next, install the software. For details, please refer the "Starter Guide." 1-5
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 8
    down the required information for the wireless LAN manual setting on P.1-7. ( MEMO ) This information will Canon MF/LBP Wireless Setup Assistant" in the User Software CD-ROM that is supplied with the machine . 6. Press [OK]. See Wireless LAN Setting Guide to perform settings. OK 7. Press [ ]
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 9
    Setting the wireless LAN 9. Press [ ] or [ ] to select the access point you wrote down in step 2, and then press [OK]. If multiple matched SSIDs are displayed, select the ID that is listed first (the one with the strongest signal). Select Access Point SampleABCD WEP 13 SampleEFGHIJ WPA-PS SampleKL
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 10
    ," on p.2-2. 13. Wait until the machine retrieves the IP address automatically (approx. 2 minutes). If you want to set the IP address manually, see the following. e-Manual "Network Settings" - "Basic Network Settings" . Next, install the software. For details, please refer the "Starter Guide." 1-8
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 11
    Troubleshooting Troubleshooting This section describes the causes and solutions for the problems occurred during wireless LAN settings. To set and operate the wireless LAN router or access points Please read the instruction manual Check PSK settings 2-3 If Problems Occur The SSID of the wireless
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 12
    Troubleshooting When an Error manually selecting an access point Cause The machine cannot detect the wireless LAN routers or access points because there is a problem wireless LAN router or access point that you are using supports the WPS function. ( Proceed to "Selecting a Method for Setting the
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 13
    Troubleshooting "Wireless connection failed." Cause Solution An error occurred on the machine while specifying the settings, resulting in a communication failure. Turn the machine OFF and ON, then set the machine again. Proceed to "Step4-A Setting the Machine Using the WPS (Push Button Mode)," on
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 14
    Troubleshooting If Problems Occur The SSID of the wireless LAN router or access point is not "Step4-B Setting the Access Point Manually and Connecting," on p.1-6. The machine cannot detect the wireless LAN routers or access points because there is a problem with the network connection. Check the
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 15
    LAN router or access point, and specify the setting again. Proceed to "Step4-A Setting the Machine Using the WPS (Push Button Mode)," on p.1-4. Proceed to "Step4-B Setting the Access Point Manually and Connecting," on p.1-6. The wireless LAN routers or access point network key is not correctly
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 16
    Troubleshooting Checking Network Connections Check the following items to make sure that the machine is ready to be connected Proceed to "Step4-A Setting the Machine Using the WPS (Push Button Mode)," on p.1-4. Proceed to "Step4-B Setting the Access Point Manually and Connecting," on p.1-6. Refer
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 17
    Troubleshooting Did you change the wireless LAN routers or access points security settings? If the following is the case, specify the settings manually. e -manual "Network Setting" - "Basic Network Setting"- "Connecting to Wireless LAN" - "Setting by Manually read the instruction manual for the wireless
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 18
    [ ], and then press [OK]. Status Monitor/Cancel TX Job RX Job Fax Forwarding Erro... Network Information 3. Select with [ ] and [ ], and then :/// in the address field, and then press the [ENTER] key on your keyboard. The is the address noted
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 19
    Canon MF/LBP Wireless Setup Assistant." * "Canon MF/LBP Wireless Setup Assistant" is included in the supplied User Software CD-ROM with the machine. 1. Insert the User the procedure up to Step 8 in "Setting the Access Point Manually and Connecting" (P.1-6). 3. Select the SSID that matches the one
  • Canon LASER CLASS 650i | Wireless LAN Guide - Page 20
    MARKETING JAPAN INC. 16-6, Konan 2-chome, Minato-ku, Tokyo 108-8011, Japan CANON U.S.A., INC. One Canon Plaza, Lake Success, NY 11042, U.S.A. CANON EUROPA N.V. Bovenkerkerweg, 59-61, 1185 XB Amstelveen, The Netherlands CANON CHINA CO. LTD. 15F Jinbao Building No.89, Jinbao Street, Dongcheng District
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

Read this guide before setting up the wireless LAN
This guide describes the wireless LAN setup procedure and
problems encountered during the configuration.
After you finish reading this guide, store it in a safe place for
future reference.
Starter Guide
Troubleshooting
XXXXXXXXX
P.2-1
P.1-1
W
ireless LAN Setting Guide
For procedures other
than printer installation
and wireless LAN setup,
please refer to the
[Starter Guide].
Setting the
wireless LAN