Canon PIXMA MP280 On-Screen Manual - Page 503

Scanning Multiple Documents at One Time with ScanGear (Scanner Driver) Page 503 of 707 pages Advanced Guide > Scanning > Scanning with Other Application Software > Scanning with Advanced Settings Using ScanGear (Scanner Driver) > Scanning Multiple Documents at One Time with ScanGear (Scanner Driver) S208 Scanning Multiple Documents at One Time with ScanGear (Scanner Driver) You can scan two or more photos (small documents) on the Platen at one time on the Basic Mode tab and Advanced Mode tab of ScanGear (scanner driver). This section explains how to scan multiple documents from the Basic Mode tab. Important To scan multiple documents as a single image, scan in whole image view. The following types of documents may not be cropped correctly. In that case, adjust the cropping frames (scan areas) in whole image view and scan. - Photos that have a whitish border - Documents printed on white paper, hand-written text, business cards, etc. - Thin documents - Thick documents Scanning Multiple Documents in Whole Image View The following types of documents cannot be cropped correctly. - Documents smaller than 1.18 inches (3 cm) square - Photos that have been cut to various shapes Note See "Scanning in Auto Scan Mode " to scan easily by automatically detecting the document type. You can also scan multiple documents at one time from the Advanced Mode tab. Use the Advanced Mode tab to make advanced scan settings such as the color mode, output resolution, image brightness and color tone. See the corresponding sections below for details on the Basic Mode tab and Advanced Mode tab. Basic Mode Tab Advanced Mode Tab 1. Place the document on the Platen, then start ScanGear. Placing Documents Starting ScanGear (Scanner Driver) 2. Set Select Source according to the document placed on the Platen.