Canon PIXMA MX320 On-Screen Manual - Page 685

Fax settings Page 685 of 817 pages When faxing color documents using the ADF, selects whether to scan it in black & white if the recipient's fax machine does not support color faxing. TX report Enables/disables automatic printing of a transmission report after a fax transmission. TX Report If you select Print error only or Print for each TX, you can enable/disable printing of the first page of the fax under the report. Dial tone detect Avoids mistransmission when reception and transmission occur at the same time. If you select ON, the machine transmits the fax after confirming the dial tone. This setting may not be supported depending on the country or region of purchase. Fax number re-entry If you select ON, you can set the machine to send faxes after using the Numeric buttons to dial the number twice. By using this setting, you can avoid the mistransmission of faxes. Check RX fax info If you select ON, the machine checks whether the recipient's fax machine information matches the dialed number. If it matches the number, the machine starts to send faxes. Reception settings ECM RX This machine is set to send/receive faxes in Error Correction Mode (ECM) by default. Transmission/Reception of Faxes Using ECM When the sender's fax machine is compatible with ECM, it resends the fax after correcting errors automatically. When the sender's fax machine is not compatible with ECM, the fax will be sent/received in the standard mode. ECM reception can be disabled. Fax priority mode Specifies the detailed settings when Receive mode set. is set to Fax priority mode. Receiving Faxes Ring start time Specifies the length of time, in seconds, to allow the machine to judge whether an incoming call is a fax or a voice call. Telephone ring time Specifies the length of time, in seconds, that the machine rings for a voice call. Default action Sets whether to receive the fax after the specified ring time has elapsed. DRPD: Fax ring pat. Sets the distinctive ring pattern of a call that the machine assumes is a fax call. If you subscribe to a DRPD service, set the ring pattern to match the pattern assigned by your telephone company. You can select the ring pattern from Normal ring, Double ring, Short-short-long, Short-long- short, and Other ring type. Setting the Receive Mode This setting is available only in the US and Canada. Ring count Specifies the number of times the external device rings when the receive mode is set to Fax only mode or Fax priority mode. Setting the Receive Mode Manual/auto switch Sets whether to automatically receive faxes after the external device rang a specified length of time when Receive mode set. is set to TEL priority mode.