Canon PIXMA MX350 Network Setup Troubleshooting - Page 11

Entering the Access Point's Wireless LAN Settings Directly on the Machine Action Enter the access point name/network name (SSID) and security setting (WEP, WPA, etc.) on the machine directly. Follow the procedure below. 1 Press the Setup button. 2 Use the [ or ] button to select Wireless LAN Setup, then press the OK button. 3 Select Yes, then press the OK button. • When wireless connection is enabled, the Wi-Fi lamp lights blue. 4 Use the { or } button to select Other setup, then press the OK button. 5 Select Advanced setup, then press the OK button. 6 Select Directly enter the access point name, then press the OK button. • If you are living in an apartment, nearby access points in use may be detected. 7 Enter the access point name/network name (SSID) using the Numeric buttons, then press the OK button. For details on how to enter characters, refer to "Character Entry" on page 8. • Enter the same access point name/network name (SSID) as that of the access point on the machine. • For details on how to check the access point name/network name (SSID), refer to the manual supplied with the access point or contact its manufacturer. • Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive. 8 Make sure that the access point name/network name (SSID) is correct, then press the OK button. 9 Select a security protocol for the access point, then press the OK button. • Go to either of the following steps according to the selected security protocol. Disable Go to on page 10. WEP Go to on page 10. WPA/WPA2 Go to on page 10. • When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility), select WEP. • When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-PSK (AES).