Canon PIXMA MX432 Guide for Printer Setup for Network
Canon PIXMA MX432 Manual
View all Canon PIXMA MX432 manuals
Add to My Manuals
Save this manual to your list of manuals |
Canon PIXMA MX432 manual content summary:
- Canon PIXMA MX432 | Guide for Printer Setup for Network - Page 1
Setup Guide This guide provides information for setting up a network connection for the printer. Wireless Connection Preparation for Connection Printer Setup Setup Procedure Selection Push Button Method WPS Troubleshooting - Canon PIXMA MX432 | Guide for Printer Setup for Network - Page 2
," which establishes a direct connection to the computer over a wireless connection without an access point, is not supported. Be sure to prepare an access point. b Printer Setup 1. Press the Setup button (A) on the printer. 2. Use the or button (A) to select Device settings. 3. Press the OK button - Canon PIXMA MX432 | Guide for Printer Setup for Network - Page 3
the OK button. 6. Select Wireless LAN setup. 7. Press the OK button. The (blue) Wi-Fi lamp (A) lights up when wireless connection is enabled. The printer will automatically search for access points supporting WPS (Wi-Fi Protected Setup). c Setup Procedure Selection Push Button Method → d-A WPS - Canon PIXMA MX432 | Guide for Printer Setup for Network - Page 4
, refer to the access point manual. 2. Press the OK button on the printer within 2 minutes. The (blue) Wi-Fi lamp on the printer flashes while searching for or connecting to the access point. 3. When the left screen appears, press the OK button. 4. Press the COPY button (A). The network connection - Canon PIXMA MX432 | Guide for Printer Setup for Network - Page 5
, refer to the access point manual. 6. Press the OK button on the printer within 2 minutes. The (blue) Wi-Fi lamp on the printer flashes while searching for or connecting to the access point. 7. When the left screen appears, press the OK button. 8. Press the COPY button (A). The network connection - Canon PIXMA MX432 | Guide for Printer Setup for Network - Page 6
Troubleshooting WPS Multiple APs detected The screen appears when multiple access points are detected. Wait for a while, then configure WPS settings again. Press the WPS button on only one access point. Failed to connect The screen appears when an error occurs. Check the access point settings,
Setup Guide
This guide provides information for setting up a network connection for the printer.
Wireless Connection
Preparation for Connection
Printer Setup
Setup Procedure Selection
Push Button Method
WPS
Troubleshooting