Canon PIXMA MX892 Guide for Printer Setup for Network - Page 22

The device may not be able to connect to the network in the following cases, To perform Advanced - instruction manual

Get Canon PIXMA MX892 PDF manuals and user guides View all Canon PIXMA MX892 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

 The device may not be able to connect to the network in the following cases: If the DHCP function of the access point is inactive, enable the DHCP function or specify the IP address (IPv4 only) of the printer and configure wireless connection settings again. In addition, make sure that the selected WEP key number and entered WEP key are correct. For details on how to check or change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. To specify the IP address of the printer, follow the procedure below. 1. Press the MENU button. 2. Select Setup, then press the OK button. 3. Select Device settings, then press the OK button. 4. Select LAN settings, then press the OK button. 5. Select Other setup, then press the OK button. 6. Select TCP/IP settings, then press the OK button. 7 Select IPv4, then press the OK button. 8. Select Yes, then press the OK button. 9. Select IP address, then press the OK button. 10. Select Manual setup, then press the OK button. Follow the on-screen instructions to proceed with settings. When the setup is complete, press the MENU button.  To perform Advanced setup again 1. Press the MENU button (A). 2. Use the buttons (B) to select Wireless LAN setup, then press the OK button.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
The device may not be able to connect to the network in the following cases:
If the DHCP function of the access point is inactive, enable the DHCP function or specify the IP address (IPv4 only)
of the printer and configure wireless connection settings again. In addition, make sure that the selected WEP key
number and entered WEP key are correct.
For details on how to check or change the settings of the access point, refer to the manual supplied with the access
point or contact its manufacturer.
To specify the IP address of the printer, follow the procedure below.
1. Press the MENU button.
2. Select Setup, then press the OK button.
3. Select Device settings, then press the OK button.
4. Select LAN settings, then press the OK button.
5. Select Other setup, then press the OK button.
6. Select TCP/IP settings, then press the OK button.
7
Select IPv4, then press the OK button.
8. Select Yes, then press the OK button.
9. Select IP address, then press the OK button.
10. Select Manual setup, then press the OK button.
Follow the on-screen instructions to proceed with settings.
When the setup is complete, press the MENU button.
To perform Advanced setup again
1. Press the MENU button (A).
2. Use the
buttons (B) to select Wireless LAN setup, then press the OK button.