Canon PIXMA iP5200 Service Manual - Page 14
Warnings, 2-4. Troubleshooting by Symptom, See Adjustment / Settings, 5 Service mode - troubleshooting guide
View all Canon PIXMA iP5200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Continuous alternate blinking Alarm LED lit [6500] ROM error RAM error - Logic board ass'y (QM2-2733)*1 - Logic board ass'y (QM2-2733)*1 *1: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROM information print). If the waste ink amount is 7% or more, also replace the ink absorber kit (QY5-0152) when replacing the logic board ass'y. [See Section 3-3. Adjustment / Settings, (5) Service mode, for details.] 2-3. Warnings Printer (no LED indications): Displayed warning Low ink Print head temperature rise Remarks - Status monitor indication. - The ink tank lamp flashes slowly (at about a second interval). If the print head temperature is high when the access cover is opened, the warning is displayed*1. When the print head temperature falls, the warning is released. Protection of excess rise of the print If the print head temperature exceeds the specified limit, a Wait head temperature is inserted during printing, *1: If the warning is displayed, the carriage does not move to the ink tank replacement position when the access cover is opened. 2-4. Troubleshooting by Symptom Symptom The power does not turn on. The power turns off immediately after power-on. Solution Replace the - AC adapter, or - logic board ass'y*1. Remarks Faulty operation A strange noise occurs. Remove foreign material, or attach a removed part if any. Printing stops mid-way. Replace the logic board ass'y*1. Multiple sheets feed. Replace the - sheet feed unit, or - cassette. Paper feed problems Paper does not feed. Paper feeds at an angle. Remove foreign material, or replace the - sheet feed unit, or - cassette. Remove foreign material, adjust the paper guide, or replace the 1-9