Canon S630 S630 Easy Setup Instructions
Canon S630 - S 630 Color Inkjet Printer Manual
 |
UPC - 013803009101
View all Canon S630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Canon S630 manual content summary:
- Canon S630 | S630 Easy Setup Instructions - Page 1
tape from the front and sides of the printer. Start Here Easy Setup Instructions 3 Install the Printhead 1 Remove the printhead from its package. S630 Series Color Bubble Jet Printer Shipping tape 2 Plug the power cord into the back of the printer and connect the other end to a power outlet - Canon S630 | S630 Easy Setup Instructions - Page 2
being used. IMPORTANT: If your computer cannot detect a printer port, refer to the Troubleshooting chapter in the S630 Quick Start Guide for instructions. 8 When the Terminate Installation window appears, click OK. 4 Click Install. The printer driver will load automatically. 5 If the message "No
-
1 -
2
 |
 |
Install the Ink Tanks
Unpack the Printer
1
2
3
4
5
Prepare the Printer
Install the Printhead
Color Bubble Jet
™
Printer
Connect the Printer
To Your Computer
Start Here
Easy Setup Instructions
IMPORTANT:
Be sure printer is off
before continuing, or the computer
will attempt to install the printer
driver before the printer is ready.
Turn the printer off.
Connect one end of the USB cable
to the computer, the other to the printer.
For Parallel Cables:
Turn the printer off.
Connect one end of the parallel cable to
the computer, the other to the printer.
IMPORTANT:
Be sure printer is off
before continuing, or the computer
will attempt to install the printer
driver before the printer is ready.
Continue with Step 6
on side two.
1
2
1
2
For USB Cables:
(IEEE 1284 compliant)
Parallel cable
Parallel port
Secure
wire clips
Parallel cable
USB port
USB cable
Protective cap
Pull the orange tab off the yellow ink tank
(BCI-3eY), then remove and discard the
plastic wrapper.
Twist off and discard the orange
protective cap.
NOTE:
To avoid spilling ink, never press on
the sides of an ink tank.
Insert the ink tank into the correct slot.
(Refer to the color guide on the printhead.)
Press down gently until the ink tank locks
into place.
Insert the remaining three ink tanks into
their assigned slots.
Close the front cover and attach the
paper rest and output tray.
2
1
3
4
5
Electrical contacts
Slide the printhead into the holder. The
printhead will rest at a slight angle.
Do not press it down.
Remove the printhead from its package.
Turn the printhead over, then remove
the orange protective cap.
NOTE:
Do not touch the electrical contacts.
Lower the lock lever and press it down
until it locks firmly into place.
Raise the gray lock lever.
3
4
5
2
1
POWER
lamp
POWER
button
Serial number
Protective tape
Shipping tape
Plug the power cord into the back of the
printer and connect the other end to a
power outlet.
Open the front cover. The printhead holder
automatically moves to the center. Remove
the protective tape.
Write down the serial number located to
the right of the printhead. You will need
this later to register the product.
3
4
5
1
Remove the shipping tape from the front
and sides of the printer.
2
USB port
Press the POWER button to turn the
printer ON.
Ink tanks
BCI-3eC Cyan
BCI-3eM Magenta
BCI-3eBK Black
BCI-3eY Yellow
Power cord
S630 Series
Color Bubble Jet Printer
Documentation
and software kit
S630 BJ (Bubble Jet) Printhead
Paper rest
Output tray
Carefully remove all items from the box.
1